Quick start guide

Tip
See the User Manual for how to
connect other equipment to this
system.
1
2
3
4
In standby mode, press and hold CLOCK on the remote.
When the hour digits flash, turn VOLUME-/+ on the system or press VOL+/- on the
remote to set the hours.
Press CLOCK again and the minute digits flash. Then turn VOLUME-/+ on the system or
press VOL+/- on the remote to set the minutes.
Press CLOCK again to confirm the time setting.
1
2
3
Connect the speaker cables.
Connect the FM antenna.
Connect the power cord of the system.
Setting the clock
IMPORTANT!
– To set clock in the Eco Power mode, press and hold ECO POWER/STANDBY-ON
2 on the set for 3
seconds or more to switch to normal standby mode first before proceeding with the procedures below.
Speaker
(left)
Speaker
(right)
FM antenna
AC power cord
MCM710 QSG_Eng 2007.12.7, 10:422