Register your product and get support at www.philips.
(in standby mode) (in standby mode)
E n g l i sh Contents 1 Important Safety Notice 2 Your Micro Hi-Fi System Introduction What’s in the box Product overview 3 Get started Connect speakers Connect FM antenna Connect power Prepare the remote control Set clock Demonstrate the unit’s features Adjust brightness of display panel Turn on or off LED light Turn on Switch to standby mode 4 Play Basic play operations Play from disc Play from USB Adjust sound 5 Listen to FM radio Plug and play installation Tune to FM radio stations Program radio st
1 Important Safety Know these safety symbols h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. j Only use attachments/accessories specified by the manufacturer.
• Remove batteries when the unit is not used for a long time. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. o Apparatus shall not be exposed to dripping or splashing. p Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). q Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. This product complies with the radio interference requirements of the European Community. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.Philips.com/welcome.
Product overview Main unit SOURCE a b n ml d c k j f i g h g a • c / • • Skip to the previous/next track. Skip to a preset station. • Start or pause play. d e • Switch to ECO Power or standby mode. b SOURCE • Select a source. / • • Search backward or forward. Search to a radio station. f • • • 8 e EN Stop play. Erase a program. (In standby mode) Turn on/off Demo mode. Open or close the disc compartment. h VOLUME • Adjust volume. • Adjust time.
c SHUFFLE • Play tracks randomly. n d SLEEP • Set the sleep timer. • Connect to a USB flash drive. e Remote control • • Navigate through menu. ALBUM/ : Skip to previous/next album. a w v u t OK • Confirm an entry or selection. • Select FM stereo or mono. b c d e s r f f RDS/INFO • For selected FM radio stations: display RDS information. • Display the current status or the disc information. • Display the ID3 information (if available) of MP3 tracks.
n PROGRAM • Program radio stations. • Program tracks. o VOL +/• Adjust volume. • Adjust time. p LOUDNESS • Turn on or off automatic loudness adjustment. q • Mute or restore volume. • Start or pause play. r s MENU • Access menu. • This button is not workable for this model. t TIMER • Set alarm timer. u • Open or close the disc compartment. v REPEAT • Select a repeat play mode. w Source buttons • Select a source. • DOCK source is not available for this unit.
For the speaker side: Connect power Unscrew the speaker connectors. For the left speaker, identify the speaker cable that is connected to the left connectors on the main unit. 3 Insert fully the red end of the speaker cable into the red (+) connector. 4 Screw the red (+) connector to secure the cable. 5 Insert fully the silver end of the speaker cable into the black (-) connector. 6 Screw the black (-) connector to secure the cable. 7 Repeat steps 2-6 for the right speaker.
a b Demonstrate the unit’s features 1 In the standby mode, press until “DEMO ON” is displayed. » Available features are displayed one by one. • c To turn off the demonstration, press again. Adjust brightness of display panel Note Press DIM repeatedly to select different brightness levels. • If you are not going to use the remote control for a long time, remove the batteries. • Do not use old and new or different types of batteries in combination.
Play from USB E n g l i sh 4 Play Basic play operations You can control play through following operations. Key / Function Press and hold to fast-forward/fastreverse the track during playback, then release to resume play. To pause/resume play during playback. INFO Select different play information. REPEAT To select a repeat play mode: [REP] (repeat): play current track repeatedly. [REP ALL] (repeat all): play all tracks repeatedly. Press again to return to normal play. SHUFFLE To play tracks randomly.
Adjust sound During play, you can change volume through following operations. Key VOL +/- Function To increase/decrease the volume. To mute/restore sound. LOUDNESS To turn on/off automatic loudness control. BASS To activate bass, press BASS and then change the bass level with VOL +/-. TREBLE To activate treble, press TREBLE and then change the treble level with VOL +/-.
4 Repeat the previous steps to program other stations. E n g l i sh Note • [STEREO] is default setting for tuner mode. Note Tip • To overwrite a programmed station, store another station in its place. • Under tuner mode, you can press OK repeatedly to toggle between [STEREO] and [MONO], and the unit memorizes your setting even if you turn off the unit or turn to other sources. Program radio stations automatically Note • You can program a maximum of 20 preset radio stations.
6 Other features Set the sleep timer Set alarm timer This unit can switch to standby automatically after a set period of time. This unit can be used as an alarm clock. You can select CD, FM or USB as alarm source. 1 Note • Make sure that you have set the clock correctly. 1 In standby mode, press and hold TIMER until [TIMER SET] scrolls on the display. 2 Press source buttons on the remote control to select a source: CD/MP3, TUNER, USB. 3 Press TIMER to confirm.
Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power Frequency Response Signal to Noise Ratio Aux Input 2 X 30 W RMS 20-20000 Hz, ±3 dB Tuning Range Tuning grid - Mono, 26 dB S/N Ratio - Stereo, 46 dB S/N Ratio Search Sensitivity Total Harmonic Distortion Signal to Noise Ratio FM: 87.5 - 108 MHz 50KHz <22 dBf <43 dBf <28 dBf <2% >55 dB Speakers Speaker 4 ohm Impedance Speaker Driver 13 cm woofer + 2.
USB playability information Supported USB storage devices: • USB flash memory (USB 2.0) Supported formats • MP3 (bit rates 32-320 kbps) • WMA (bit rates 32-320 kbps) • MP3 ID3 tag (Ver 2.0) • WMA ID3 tag Unsupported formats: • Empty albums: an empty album is an album that does not contain MP3/ WMA files, and is not shown in the display. • Unsupported file formats are skipped. For example, Word documents (.doc) or MP3 files with extension .dlf are ignored and not played. • Video and photo files.
• • • Reduce the distance between the remote control and the unit. Insert the battery with its polarities (+/– signs) aligned as indicated. Replace the battery. Aim the remote control directly at the sensor on the front of the unit. E n g l i sh • No disc detected • Insert a disc. • Check if the disc is inserted upside down. • Wait until the moisture condensation at the lens has cleared. • Replace or clean the disc. • Use a finalized CD or correct format disc.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. MCM7000_12_UM_V1.
