Quick start guide

ManualsBrandsPhilips ManualsHi-FiHiFi-Microsystem

MCM279

Quick Start Guide

What’s in the Box?

You should find these items upon opening the box.

Prepare

Install

Enjoy

Step A

Step

CR2025

User Manual

User manual

Remote control with

1 x CR2025 battery

Stand FM wire antenna

Quick Start Guide

Quick start guide

Power adaptor

MW antenna

MCM279 QSG_12_Eng 5/16/08, 12:121

Summary of content (4 pages)

PAGE 1
MCM279 Quick Start Guide Step A Install Step B Prepare Step C What’s in the Box? Enjoy You should find these items upon opening the box.
PAGE 2
Install Mounting the stand onto the set 1 Locate the bottom of the main unit and find the slot, then slide the stand in the slot until it stops, as indicated in the figure. Rear connections 1 Tip – To receive optimal radio reception, put the main unit and the antennas as far away as possible from the power adaptor. Connect the cable of the left speaker to LEFT (red and black) and the cable of the right speaker to RIGHT (red and black). 2 Extend the wire antenna and fit it to FM ANTENNA.
PAGE 3
Setup Setting the clock 1 2 3 Press and hold STANDBY-ON/ ECO POWER y to switch the set to Standby mode. ➜ The display shows the set time. ➜ -- --:-- -- displays by default if you have not set the clock. In the standby mode, press and hold DISPLAY/CLOCK (or CLOCK on the remote control). ➜ The hours digits start flashing. To switch between 12 hour and 24 hour display, press PROGRAM (or PROG on the remote control) repeatedly to set the hours. 4 Hold down or press VOLUME +/- repeatedly to set the hours.
PAGE 4
Enjoy Tuning to radio stations 1 Press SOURCE (or TUNER on the remote control) once or more to select TUNER. 2 Press and hold PROGRAM (or PROG on the remote control) until AUTO appears. ➜ Available stations (RDS, FM and MW) are programmed. 3 Press ALBUM/PRESET +/- (or 3/4 on the remote control) buttons once or more until the desired preset station is displayed. Playing a USB mass storage device With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1), USB flash players (USB 2.0 or USB1.