User guide

Tape Operation / Recording
Tape playback
Select TAPE source.
The display shows 'TAPE” briefly.
Press OPEN A to open the tape door
Insert a recorded tape and close the tape door
Load the tape with the open side downward and
the full spool to the left.
Press ►!! to start playback.
To stop playback
• Press ■.
To reset the tape counter display
# In stop mode, press ■ once.
Rewinding / Fast forwarding
1 Stop playback, press or {« or ►►).
The tape will stop automatically at the end of
rewinding or fast forwarding.
^ During fast winding, you can monitor the tape
message with the tape counter.
2 Press ■ to stop rewinding or fast forwarding.
Note;
- During rewinding or fast forwarding of a tape, it
is also possible to select another source (CD or
TUNER, for example).
General information on
recording
For recording, use only NORMAL (EC type I)
tapes on which the tabs have not yet been
broken.This deck is not suited for recording on
METAL (EC IV) type tapes.
The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND or DBB will not affect the
recording in progress.
At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however; you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
IMPORTANT!
Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
I
pg 001-020/M250/21-Eng
4-
4/16/02.7:05 PM
15
3140115 29261