MCM239D Quick Start Guide Step A Install Step B Prepare Step C What’s in the Box? Enjoy You should find these items upon opening the box.
Install Mounting the stand onto the set 1 Locate the bottom of the main unit and find the slot, then slide the stand in the slot until it stops, as indicated in the figure. Rear connections MW loop antenna Speaker (left) Speaker (right) FM wire antenna Power adaptor 1 Connect the cable of the left speaker to LEFT (red and black) and the cable of the right speaker to RIGHT (red and black).
Setup Setting the clock 1 Press and hold STANDBY-ON/ ECO POWER y to switch the set to Standby mode. ➜ The display shows the set time. ➜ -- --:-- -- flashes by default if you have not set the clock. 2 In the standby mode, press and hold DISPLAY/CLOCK on the remote control. ➜ 24 HR or 12 HR appears for the initial clock setting. To select 12-hour clock or 24-hour clock, 1. Press VOLUME +/- once or more. 2. Press DISPLAY/CLOCK to confirm. ➜ The hours digits start flashing.
Enjoy Tuning to radio stations 1 Press SOURCE once or more to select TUNER (or TUNER on the remote control). 2 3 Press and hold PROGRAM until AUTO appears ➜ Available stations are programmed in order of waveband reception strenght: RDS, FM followed by MW. Press the ALBUM/ PRESET buttons once or more until the desired preset station is displayed. Playing a USB mass storage device With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1), USB flash players (USB 2.0 or USB1.
Enjoy Playing iPod using the dock 1 Select the correct dock adaptor supplied, then snap the adaptor into the dock connector to provide a snug fit for the player. ● The indication on the adaptor’s back fits specific iPod player. 2 Correctly place your player in the dock connector. 3 Connect the cables of the dock to DOCK IN jacks on the main set correspondingly. 4 Press SOURCE repeatedly or on the set (or iPod on the remote) to select DOCK source. ● The connected player will play automatically.
