Quick start guide

ManualsBrandsPhilips Manualsaudio & home theatreMCM239/12

MCM239

Quick Start Guide

What’s in the Box?

You should find these items upon opening the box.

Prepare

Install

Enjoy

Step A

Step

CR2025

User Manual

User manual

Remote control with

1 x CR2025 battery

Stand FM wire antenna

Quick Start Guide

Quick start guide

Power adaptor

MW antenna

MCM239 QSG_-12-Eng 22/8/07, 15:251

Summary of content (4 pages)

PAGE 1
MCM239 Quick Start Guide Step A Install Step B Prepare Step C What’s in the Box? Enjoy You should find these items upon opening the box.
PAGE 2
Install Mounting the stand onto the set 1 Locate the bottom of the main unit and find the slot, then slide the stand in the slot until it stops, as indicated in the figure. Rear connections 1 Connect the cable of the left speaker to LEFT (red and black) and the cable of the right speaker to RIGHT (red and black). Tip – To receive optimal radio reception, put the main unit and the antennas as far away as possible from the power adaptor. 2 Extend the wire antenna and fit it to FM ANTENNA.
PAGE 3
Setup Setting the clock 1 Press and hold STANDBY-ON/ ECO POWER y to switch the set to Standby mode. ➜ The display shows the set time. ➜ -- --:-- -- flashes by default if you have not set the clock. 2 In the standby mode, press and hold DISPLAY/CLOCK on the remote control. ➜ 24 HR or 12 HR appears for the initial clock setting. To select 12-hour clock or 24-hour clock, 1. Press VOLUME +/- once or more. 2. Press DISPLAY/CLOCK to confirm. ➜ The hours digits start flashing.
PAGE 4
Enjoy Tuning to radio stations 1 Press SOURCE once or more to select TUNER (or TUNER on the remote control). 2 3 Press and hold PROGRAM until AUTO appears ➜ Available stations are programmed in order of waveband reception strenght: RDS, FM followed by MW. Press the ALBUM/ PRESET buttons once or more until the desired preset station is displayed. Playing a USB mass storage device With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1), USB flash players (USB 2.0 or USB1.