Always there to help you Register your product and get support at www.philips.
Contents 1 Important 3 Safety Notice 3 4 2 Your Micro Music System 5 3 Get started 8 Introduction What's in the box Overview of the main unit Overview of the remote control Connect speakers Connect FM aerial Connect power Prepare the remote control Turn on Set clock Demonstrate the unit's features Store radio stations automatically 5 5 6 7 11 5 Listen to FM radio 12 6 Other features 13 Tune to FM radio stations Program radio stations automatically Program radio stations manually Tune to a pr
1 Important • • • Safety The device shall not exposed to dripping or splashing. Do no place any source of danger on the device (e.g. liquid filled objects. lit candles). Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation..
To establish a safe volume level: • Set your volume control at a low setting. • Slowly increase the sound until you can hear it comfortably and clearly, without distortion. Listen for reasonable periods of time: • Prolonged exposure to sound, even at normally ‘safe’ levels, can also cause hearing loss. • Be sure to use your equipment reasonably and take appropriate breaks. Be sure to observe the following guidelines when using your headphones. • Listen at reasonable volumes for reasonable periods of time.
programs, files, broadcasts and sound recordings, may be an infringement of copyrights and constitute a criminal offence. This equipment should not be used for such purposes. 2 Your Micro Music System This apparatus includes this label: Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction Note •• The type plate is located on the bottom of the main unit.
Overview of the main unit n a m b c d e l f g k h i a Disc compartment • Hold a disc. b • e h USB socket. c AUDIO IN • Connect an external audio device. d j • Headphone socket. • • Turn on or off the unit. Switch to standby mode or Eco Power standby mode. f IR sensor • Detect signals from the remote control. g SOURCE • Select a source. i j / In DISC and USB modes, skip to previous/next track. • In DISC and USB modes, search within a track. • Tune to a radio station.
n VOLUME • Adjust volume. • Adjust time. a Overview of the remote control b d b CD FM PRESET/ALBUM s r q d e p USB f DISPLAY RDS o g h Mute or restore volume. / In DISC and USB modes, skip to previous/next track. • In DISC and USB modes, search within a track. • Tune to a radio station. • e USB • Select USB source. f RDS • For selected FM radio stations: display RDS information. • Synchronize clock with an RDS station. g • • Stop play. Erase a program.
n REPEAT/SHUFFLE • Play tracks randomly. • Select a repeat play mode. o DISPLAY • Display play information. • Show time during USB and disc playback. p AUDIO IN • Select AUDIO IN source. q • • Start or pause play. Select FM stereo or FM mono. r PRESET/ALBUM / / • In DISC and USB modes, skip to previous/next album. • Select a preset radio station. s FM • Select TUNER (FM radio) source.
Connect FM aerial Connect the power cable to the wall socket. Prepare the remote control Caution FM •• Risk of explosion! Keep batteries away from heat, sunshine, or fire. Never discard batteries in fire. To insert the remote control battery: 1 2 Tip 3 Open the battery compartment. Insert 2 AAA batteries with correct polarity (+/-) as indicated. Close the battery compartment. •• For optimal reception, fully extend and adjust the a position of the antenna.
Turn on Press . »» The unit switches to the last selected source. Switch to standby mode Press for over 3 seconds to switch the unit to Eco Power Standby mode. »» The backlight on the display panel turns off. To switch the unit to standby mode: In Eco Power Standby mode, press for over 3 seconds to switch to Standby mode. »» The clock (if set) appears on the display panel.s Set clock 1 2 3 4 In standby mode, press PROG/CLOCK SET for 3 seconds to activate clock setting mode.
4 Play Basic play operations You can control play through following operations. Play from disc 1 2 3 4 Press CD to select the CD source. Press .. »» The disc compartment opens. Place a disc with the printed side facing up. Press . »» The disc compartment closes, and play starts automatically. • If play does not start, press / to select a track, then press . Play from USB Note •• Ensure that the USB device contains playable audio contents in supported formats.
5 Listen to FM radio Program radio stations manually Note •• You can program a maximum of 20 preset radio stations. Tune to FM radio stations Note •• Ensure that you have connected and fully extended the supplied FM antenna. 1 2 3 1 2 3 Press FM. 4 Press and hold / to tune to a radio station. »» The FM tuner tunes to a station with strong reception automatically. 5 Press Program radio stations automatically Note •• You can program a maximum of 20 preset radio stations.
»» Program type such as [NEWS] (news), [SPORT] (sport), [POP M] (pop music)... 6 Other features »» RDS clock »» Frequency Synchronize clock with RDS You can synchronize time shown on the unit with that on the RDS station. 1 2 Tune to an RDS radio station that transmits time signals. Press RDS for over 2 seconds. »» [CT SYNC] is displayed and the unit reads RDS time automatically. »» If no time signal is received, [NO CT] is displayed. Set alarm timer This unit can be used as an alarm clock.
Tip •• Alarm timer is not available in AUDIO IN mode. •• If DISC/USB source is selected, yet no disc is placed or no USB connected, the system switches to the tuner source automatically. 7 Product information Note •• Product information is subject to change without prior Set sleep timer notice. When the unit is turned on, press SLEEP/TIMER repeatedly to select a time period (in minutes). »» When sleep timer is activated, is displayed.
• Tuner (FM) Tuning Range Tuning grid Sensitivity - Mono, 26dB S/N Ratio - Stereo, 46dB S/N Ratio Search Selectivity Total Harmonic Distortion Signal to Noise Ratio 87.5 - 108MHz 50 KHz < 22 dBf < 43 dBf <28 dBf <2% >55 dB General information AC power Operation Power Consumption Eco Standby Power Consumption Headphone Output USB Direct Dimensions - Main Unit (W x H x D) - Speaker Box (W x H x D) Weight - Main Unit - Speaker Box 220-240 V~, 50/60Hz 10W <0.5W 2x15mW 32ohm Version 2.
8 Troubleshooting Caution •• Never remove the casing of this unit. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this unit, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support). When you contact Philips, ensure that your unit is nearby and the model number and serial number are available.
Specifications are subject to change without notice. 2013 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V. MCM2005_12_UM_V2.
