MCM138D Docking Entertainment System Register your product and get support at www.philips.com/welcome User manual MCM138D_05-Eng_iPod 1 2007.8.
MCM138D_05-Eng_iPod 2 2007.8.
4 1 5 2 OP E N / C LO S E 6 7 3 STANDBY-ON SOURCE BAND PROG/CLOCK - VOLUME + TUNING M I C R O S Y S T E M MCM138D 8 iR 0 ! @ 9 # 3 MCM138D_05-Eng_iPod 3 2007.8.
Hearing Safety Listen at a moderate volume. ● Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced some hearing loss. ● Sound can be deceiving. Over time your hearing "comfort level" adapts to higher volumes of sound.
English Index English ------------------------------------------------ 6 ------------------------------------------------- 21 CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. 5 MCM138D_05-Eng_iPod 5 2007.8.
Contents English General Information Clock/Timer Environmental information ................................ 7 Supplied accessories ............................................ 7 Safety information ................................................ 7 Setting the clock ................................................. 15 Setting the timer ................................................. 15 Activating and deactivating TIMER ................. 15 Activating and deactivating SLEEP ..................
Congratulations on your purchase and welcome to Philips! To fully benifit from the support that Philips offers, register your product at www.philips.com/welcome. Supplied accessories – – – – 2 speaker boxes MCM138D remote control with battery MW loop antenna Docking kit - 1 dock used for both Apple iPod - Dock adaptors (8 adaptors for different iPod types) Environmental Information All unnecessary packaging has been omitted.
Preparations English MW antenna FM antenna Speaker (left) Speaker (right) AC powr cord A Rear connections B Antennas Connection The type plate is located at the rear of the system. 1 Power – Before connecting the AC power cord to the wall outlet, ensure that all other connections have been made. WARNING! – For optimal performance, use only the original power cable. – Never make or change any connections with the power switched on.
C Speakers Connection English Preparations Before using the remote control Front Speakers Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left speaker to "LEFT", the wire (marked red) to "+" and the wire (marked black) to "-". 1 2 Pull out the plastic protective sheet. 3 Then select the desired function (for example É, í, ë). Select the source you wish to control by pressing one of the source select keys on the remote control (for example CD, TUNER).
Controls (illustrations on page 3) English Controls on the system and remote control for Tuner.......... (on the set only) selects waveband. 2 SOURCE (CD/ TUNER/DOCK) – – switches on the system. selects the respective sound source for CD/ FM/ MW/ DOCK. 3 STANDBY-ON / y – – activates/deactivates or sets the timer function. ( ALBUM 4 3 for MP3/WMA disc...........selects an album. 1 BAND – * TIMER ) DBB – (Dynamic Bass Boost) enhances the bass.
Adjusting volume and sound OP STANDBY-ON SOURCE BAND PROG/CLOCK - VOLUME 1 Press VOLUME – / + to increase or decrease volume. ➜ Display shows the volume level and a number from 0-32. 2 Press DSC repeatedly to select the desired sound effect: JAZZ / POP / CLASSIC / ROCK. E N / C LO S E + TUNING IMPORTANT: Before you operate the system, complete the preparation procedures. Switching the system on ● In Active standby, or Eco standby, press STANDBY-ON (y on the remote control).
CD/MP3/WMA Operation English ➜ READ is displayed as the CD player scans the contents of a disc, and then the total number of tracks and playing time (or the total number of M I C R O S Y S T E M MCM138D albums and tracks for MP3/WMA disc) are shown. iR Basic playback controls POP TRK To play a disc PROG DBB MP3 ● Press 2; to start playback. ➜ The current track number and elapsed playing time of the track are displayed during disc playback.
3 Press ¡1 2™ to select a desired track. ➜ The album number will change accordingly as you reach the first track of an album by pressing ¡1 or the last track of an album by pressing 2™ . 4 Press 2; to start playback. Notes: – The SHUFFLE and REPEAT functions cannot be used simultaneously. – SHUFFLE play is not available in the programe mode. Programming track numbers ● During playback, press once ALBUM 4 3 to show the current album number. Supported MP3 disc formats: – ISO9660, Joliet, UDF 1.
Radio Reception English 3 Turn TUNING 0 to tune to a station. ➜ Display shows: the frequency of the tuned station. Helpful hints: To improve radio reception: – For FM, extend coil antenna at the back of the unit fully for optimum reception. OP STANDBY-ON SOURCE BAND PROG/CLOCK - VOLUME E N / C LO S E + TUNING Tuning to radio stations 1 Select TUNER source. ➜ TUNER is displayed. 2 Press BAND (TUNER on the remote control) once or more to select your waveband.
4 5 M I C R O S Y S T E M MCM138D iR 6 7 English Clock/Timer Press ¡1 / 2™ to set the hours. Press TIMER again. ➜ The clock digits for the minutes flash. Press ¡1 / 2™ to set the minutes. Press TIMER to confirm the time. ➜ The timer is now set and actiated. Notes: - If source CD is selected and no disc is in the CD tray or the disc has an error, TUNER will be selected automatically. - If source DOCK is selected and no iPod is docked or no dock connection is made, TUNER will be selected automatically.
Dock English Portable player Speaker (right) Speaker (left) Dock Installing the dock adaptor Playing iPod using the dock By connecting the supplied dock to your Hi-Fi system, you can listen to the sound of the docked player through the powerful speakers of the Hi-Fi system. 1 Align two holes of the dock and two latches of the adaptor, then gently push in the adaptor until it clicks.
Playing iPod 1 Select the dock adaptor of the correct type, and snap it into the dock (See “ Dock adaptor ” ). 2 3 Correctly place your iPod in the dock. Connect the cables of the dock to DOCK IN jacks on the main set correspondingly. 4 Press SOURCE repeatedly or DOCK to select DOCK source. ● The connected player will play automatically.
Troubleshooting English WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. Problem Solution ✔ Insert a disc. ✔ Check if the disc is inserted upside down.
The menu navigation or photo playback of the docked player cannot be carried out through the buttons on MCM138D or its remote control. ✔ The buttons on MCM138D and its remote The STOP 9 and some buttons on MCM138D and its remote control have no function. ✔ The playback of the docked player cannot be control can only control playback of audio contents. To navigate the menu, use the controls on the docked player. stopped using the STOP 9 button on MCM138D and its remote control.
Specifications English AMPLIFIER Output power ....................................................... 2 x 2W ..................................................................... 4W total power Signal-to-noise ratio .......................... ≥ 62 dBA (IEC) Frequency response ...... 125 – 16000 Hz, ± 3 dB Impedance loudspeakers ......................................... 8 Ω Impedance headphones ........................................ 32 Ω CD PLAYER Frequency range ..................................
规格更改恕不另行通知。 商标为荷兰皇家飞利浦电子股份有限公司或 其各自所有者的专有财产。 荷兰皇家飞利浦电子股份有限公司。版权所有。 2007 © 中国印刷 MCM138D_中文.
