Micro Hi-Fi System User manual MCM108D
4 1 5 2 OP E N / C LO S E 6 7 3 STANDBY-ON SOURCE BAND PROG/CLOCK - VOLUME + TUNING M I C R O S Y S T E M MCM108D 8 iR 0 ! @ 9 # 2
English Controls on the system and remote control 1 BAND – for Tuner.......... (on the set only) selects waveband. 2 SOURCE (CD/ TUNER/ DOCK) – – switches on the system. selects the respective sound source for CD/ FM/ MW/ DOCK. 3 STANDBY-ON / y – Controls * TIMER – activates/deactivates or sets the timer function. ( ALBUM 4 3 for MP3/WMA disc...........selects an album. ) DBB – (Dynamic Bass Boost) enhances the bass.
General Information IMPORTANT! PLEASE NOTE THAT THE VOLTAGE SELECTOR LOCATED AT THE REAR OF THIS SYSTEM IS PRESET AT 220V FROM THE FACTORY. FOR COUNTRIES THAT OPERATE AT 110V-127V, PLEASE ADJUST TO 110V-127V BEFORE YOU SWITCH ON THE SYSTEM.
Preparations MW loop antenna FM wire antenna Speaker (left) Speaker (right) AC power cord IMPORTANT! – Do not connect Mini-USB port both on the main unit and the supplied dock to a computer or any other USB devices. It is only for connecting the supplied dock and the main unit to let them work together. See the Dock section for dock connection.
Preparations C Speakers Connection Front Speakers Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left speaker to "LEFT", the wire (marked red) to "+" and the wire (marked black) to "-". Before using the remote control 1 2 3 Pull out the plastic protective sheet. Select the source you wish to control by pressing one of the source select keys on the remote control (for example CD, TUNER). Then select the desired function (for example É, í, ë).
Basic Functions Adjusting volume and sound OP STANDBY-ON SOURCE BAND PROG/CLOCK - VOLUME 1 Press VOLUME – / + to increase or decrease volume. ➜ Display shows the volume level and a number from 0-32. 2 Press DSC repeatedly to select the desired sound effect: JAZZ / POP / CLASSIC / ROCK. E N / C LO S E + TUNING IMPORTANT: Before you operate the system, complete the preparation procedures. Switching the system on ● Press STANDBY-ON (y on the remote control).
CD/MP3 Operation Basic playback controls To play a disc M I C R O S Y S T E M MCM108D ● Press 2; to start playback. ➜ The current track number and elapsed playing time of the track are displayed during disc playback. iR POP TRK PROG DBB To select a different track MP3 REP ALL ● Press ¡1 2™ once or repeatedly until the desired track number appears in the display. CD To find a passage within a track 1 IMPORTANT: The lens of the CD player should never be touched. 2 Press and hold down on ¡1 2™.
CD/MP3 Operation 3 Press ¡1 2™ to select a desired track. ➜ The album number will change accordingly as you reach the first track of an album by pressing ¡1 or the last track of an album by pressing 2™ . 4 Press 2; to start playback. Notes: – The SHUFFLE and REPEAT functions cannot be used simultaneously. – SHUFFLE play is not available in the programe mode. Programming track numbers ● During playback, press once ALBUM 4 3 to show the current album number.
Radio Reception 3 Turn TUNING 0 to tune to a station. ➜ Display shows: the frequency of the tuned station. Helpful hints: To improve radio reception: – For FM, extend coil antenna at the back of the unit fully for optimum reception. OP STANDBY-ON SOURCE BAND PROG/CLOCK - VOLUME E N / C LO S E + TUNING Tuning to radio stations 1 Select TUNER source. ➜ TUNER is displayed. 2 Press BAND (TUNER on the remote control) once or more to select your waveband.
Clock/Timer 4 5 M I C R O S Y S T E M MCM108D iR 6 7 Setting the clock 1 In Standby mode, press PROG/CLOCK button. ➜ The clock digits for the hours flash. 2 3 Press ¡1 / 2™ to set the hours. 4 5 Press ¡1 / 2™ to set the minutes. Press PROG/CLOCK again. ➜ The clock digits for the minutes flash. Press PROG/CLOCK to confirm the time. Note: – If the clock has not been set, -- --:-- -- will be displayed. Setting the timer ● The system can be used as an alarm clock.
Dock Portable player Speaker (right) Speaker (left) Dock IMPORTANT! – MCM108D comes with two dock types. Use the designated dock type, as indicated on the bottom panel of the dock supplied, to work with either Philips GoGear or Apple iPod. – Do not connect Mini-USB port both on the main unit and the supplied dock to a computer or any other USB devices. It is only for connecting the supplied dock and the main unit to let them work together.
Dock Removing the dock adaptor Push the dock in the direction of the arrow shown in the figure below to un-latch the adaptor, then take it out. Adaptor for iPod Adaptor for Philips GoGear Playing iPod /Philips GoGear 1 2 3 4 Make sure the dock type is compatibly matched with the player to be docked, as indicated on the bottom of the dock. Snap the dock adaptor of the correct type and size into the dock (See “ dock adaptor ”).
Troubleshooting WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. Problem CD OPERATION “NO cd” is displayed. RADIO RECEPTION Radio reception is poor.
Troubleshooting DOCK OPERATION The menu navigation or photo playback of the docked player cannot be carried out through the buttons on MCM108D or its remote control. The STOP 9 and some buttons on MCM108D and its remote control have no function. – The buttons on MCM108D and its remote control can control playback of audio contents only. To navigate the menu, use the controls on the docked player.
Specifications AMPLIFIER Output power ....................................................... 2 x 2W ..................................................................... 4W total power Signal-to-noise ratio .......................... ≥ 62 dBA (IEC) Frequency response ...... 125 – 16000 Hz, ± 3 dB Impedance loudspeakers ......................................... 8 Ω Impedance headphones ........................................ 32 Ω CD PLAYER Frequency range ..................................
Hearing Safety Listen at a moderate volume. ● Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced some hearing loss. ● Sound can be deceiving. Over time your hearing "comfort level" adapts to higher volumes of sound.
Meet Philips at the Internet http://www.philips.
