Micro Hi-Fi System MCM108 MCM108B MCM108C Meet Philips at the Internet http://www.philips.
English Controls on the system and remote control 1 BAND – for Tuner (on the set only) selects waveband. 2 SOURCE (CD/ TUNER/ AUX) – – switches on the system. selects the respective sound source for CD/ FM/ MW/ AUX. 3 STANDBY-ON / y – 4 1 OP 5 OPEN•CLOSE 6 – SOURCE BAND PROG/CLOCK - VOLUME + opens/closes the CD door. 6 VOLUME – / + 7 STANDBY-ON – activates/deactivates or sets the timer function. ( ALBUM 4 3 for MP3 disc......................selects an album.
General Information IMPORTANT! PLEASE NOTE THAT THE VOLTAGE SELECTOR LOCATED AT THE REAR OF THIS SYSTEM IS PRESET AT 220V FROM THE FACTORY. FOR COUNTRIES THAT OPERATE AT 110V-127V, PLEASE ADJUST TO 110V-127V BEFORE YOU SWITCH ON THE SYSTEM. Supplied accessories – 2 speaker boxes – remote control with 1 x CR2032 battery – MW loop antenna Environmental Information All unnecessary packaging has been omitted.
Preparations Basic Functions Front Speakers Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left speaker to "LEFT", the wire (marked red) to "+" and the wire (marked black) to "-". Adjusting volume and sound Before using the remote control C Speakers Connection 1 2 3 Pull out the plastic protective sheet. Then select the desired function (for example É, í, ë). OP STANDBY-ON Press VOLUME – / + to increase or decrease volume.
CD/MP3 Operation CD/MP3 Operation Basic playback controls 3 Press ¡1 2™ to select a desired track. ➜ The album number will change accordingly as you reach the first track of an album by pressing ¡1 or the last track of an album by pressing 2™ . 4 Press 2; to star t playback. To play a disc M I C R O S Y S T E M MCM108 ● Press 2; to start playback. ➜ The current track number and elapsed playing time of the track are displayed during disc playback.
Radio Reception Other Connection Clock/Timer Helpful hints: To improve radio reception: – For FM, extend coil antenna at the back of the unit fully for optimum reception. STANDBY-ON SOURCE BAND PROG/CLOCK - VOLUME 1 2 + TUNING Select AUX source. Use a line-in cable (not supplied) to connect MCM 108’s AUX-IN jack (3.5 mm ) to an AUDIO OUT or headphone jack on an external equipment (such as CD player, or VCR). AUX-IN Select TUNER source. ➜ TUNER is displayed.
Troubleshooting Specifications WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. Problem CD OPERATION “NO cd” is displayed. RADIO RECEPTION Radio reception is poor.
AUSTRALIA - Philips Manufacturers Warranty for Australia only These warranty conditions are valid for the following consumer electronics products: Colour Televisions, Projection TV, Plasma & LCD TV, Video Cassette Recorders, CD Recorders & Players, DVD Players, DVD Recorders, Audio Systems, Home Theatre systems & Portable Audio.
