Specifications

8 EN
Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
• Do not use old and new or different types of batteries
in combination.
• Batteries contain chemical substances, so they should
be disposed of properly.
Connect speakers
Note
•
For optimal sound, use the supplied speakers only.
• Connect only speakers with impedance that is the
same or higher than the supplied speakers. Refer to the
Specicationssectionofthismanual.
Insert the speaker wires completely into the
speaker input sockets on the back of the unit.
Connect power
Caution
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the rear of the main unit.
• Before connecting the AC cord, make sure that you
have completed all other connections.
Note
•
The type plate is located on the rear of the main unit.
1 Connect the power cord to the AC~jack
on the main unit.
2 Connect the power plug to the wall outlet.
Autoinstallradiostations
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1 Connect the unit to the power supply.
» [AUTOINSTALL-PRESSPLAY-
STOPCANCEL](auto install - press
play - stop cancel) is displayed.
2 Press on the main unit to start
installation.
» The unit automatically stores radio
stationswithsufcientsignalstrength.
» When all the available radio stations
arestored,therstpresetradiostation
is broadcast automatically.
Set clock
Note
•
You can set the clock in standby mode only.
1 Press to switch the unit to standby.
2 Make sure that --:-- (or clock) is displayed.
3 Press and hold CLOCKSET to activate
the clock setting mode.
» [CLOCKSET](clock set) is displayed.
» The 12 hour or 24 hour format is
displayed.