Quick start guide

Setting the clock
1
2
3
4
In standby mode, press and hold CLOCK on the remote.
When the hour digits flash, turn VOLUME-/+ on the system or press VOL +/- on the
remote to set the hours.
Press CLOCK again and the minute digits flash. Then turn VOLUME-/+ on the system or
press VOL +/- on the remote to set the minutes.
Press CLOCK again to confirm the time setting.
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connected TV does
not support progressive signals or the cables are not connected
accordingly, see the user manual for proper progressive scan setup or
deactivate the progressive scan feature as below:
1) Turn off your TV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM MENU on the remote to exit the system menu and
then DISC and “1” to exit progressive scan.
Tip
See chapters "Getting Started" and "System Menu Options" in the User Manual for detailed descriptions.
Playing a disc
1
2
Press ç to open the disc tray and load in a disc, then press the same button again to close the disc tray.
➜ Make sure the label side of the disc is facing up.
Playback will start automatically. If not pressÉÅ.
To stop playback, press 9.
3
DIVX
[
R
]
VOD
MCDB710 QUG_05_Eng 2008.5.8, 15:393