Quick Start Manual

Setting the clock

In standby mode, press and hold CLOCK/RDS on the remote.

When the hour digits flash, turn VOLUME-/+ on the system or press VOL +/- on the

remote to set the hours.

Press CLOCK/RDS again and the minute digits flash. Then turn VOLUME-/+ on the

system or press VOL +/- on the remote to set the minutes.

Press CLOCK/RDS again to confirm the time setting.

Setting DVD menu options

IMPORTANT!

If the progressive scan feature is activated but the connected TV does not support progressive

signals or the cables are not connected accordingly, see the user manual for proper progressive

scan setup or deactivate the progressive scan feature as below:

1) Turn off your TV progressive scan mode or turn on to interlaced mode.

2) Press SYSTEM MENU on the remote to exit the system menu and then DISC and “1” to exit

progressive scan.

Tip

See chapters "Preparations" and "DVD Menu Options" in the User Manual for detailed descriptions.

CLOSED CAPTIONS

Press OPEN •CLOSEç (ç on the remote) to open the disc tray and load in a disc,

then press the same button again to close the disc tray.

➜ Make sure the label side of the disc is facing up.

Playback will start automatically. If not pressÉÅ.

To stop playback, press PRESET-/9 (9 on the remote).

Playing a disc

OPEN•CLOSE

MCD759D QSG_37-Eng 2007.6.22, 9:253