DVD Micro Theater User Manual

23
Select sampling rate
You can select the Linear Pulse Code
Modulation (LPCM) output sampling rate. The
higher the sampling rate, the better the sound
quality.
1 Press SYSTEM MENU.
2 Select [AUDIO SETUP] (audio setup) >
[LPCM], and then press
.
3 Select an option and then press OK.
[• 48K]
For discs recorded at sampling rate
of 48kHz.
[• 96K]
For discs recorded at sampling rate
of 96 kHz.
[• 192K]
For discs recorded at sampling rate
of 192 kHz.
4 Press SYSTEM MENU to exit.
Enable night mode
[NIGHT MODE]
Makes loud sound level softer and soft sound
level louder so that you can watch the DVD
movies at a low volume, without disturbing
others.
1 Press SYSTEM MENU.
2 Select [AUDIO SETUP] (audio setup) >
[NIGHT MODE] (night mode), and then
press
.
3 Select an option and then press OK.
• [ON] (on)
Enjoy quiet viewing at night.
• [OFF] (off )
Enjoy surround sound with its full
dynamic range.
4 Press SYSTEM MENU to exit.
Select audio downmix
Select a suitable audio downmix when you
are playing a DVD recorded in Dolby Digital
format.
1 Press SYSTEM MENU.
2 Select [AUDIO SETUP] (audio setup) >
the [DOWNMIX] (downmix), and then
press
.
3 Select an option and then press OK.
• [LT/RT]
Select this if the unit is connected
to a Dolby Pro Logic or Dolby Pro
Logic II decoder.
• [STEREO] (stereo)
Select this when output delivers
sound from only the two front
speakers.
• [VSS]
Allows the DVD player to use virtual
surround sound effects.
4 Press SYSTEM MENU to exit.
Select reverb mode
3D processing provides a virtual surround
sound experience using just two speakers.
1 Press SYSTEM MENU.
2 Select [AUDIO SETUP] (audio setup) >
[3D PROCESSING] (3d processing), and
then press
.
3 Select an option and then press OK.
• [OFF] (off), [CONCERT] (concer t),
[CHURCH] (church), [PASSIVE]
(passive), [WIDE] (wide), or [ LIVE]
(live)
4 Press SYSTEM MENU to exit.
English
EN