User manual

14
4 Press PROG/CLOCK SET

setup.
Note
 The number key on the remote control is deactivated
in this mode.
Store radio stations
automatically
If no radio stations are stored, the unit can store
radio stations automatically.
1 Turn on the unit.
2 Press FM.
» [AUTO INSTALL -- PRESS PLAY
-- STOP CANCEL] (press
to start
automatic installation, or press
to

3 Press .
» The unit automatically stores radio

» After all available radio stations are

broadcast automatically.
Find the correct video input
channel
1 Turn on your unit.
2 Press DISC to select the disc source.
 Turn on the TV and switch to the
correct video-in channel.
Note
 See the user manual of your TV for how to switch
between video-in channels.
4 Get started
Turn on
1 Press .
»
The unit switches to the last selected
source.
Note
 If no source is played within 15 minutes, the unit
switches to standby mode.
 If no operation is performed within 15 minutes in
standby mode, the unit switches to Eco-power standby
mode.
 Press to switch the unit to the last source when it
was turned off.
Demonstrate the unit’s features
1 In the standby mode, press until “DEMO

» This system’s features are displayed
one by one.
 To turn off the demonstration, press
again.
Set the clock
The unit uses the 24-hour or 12-hour time
format.
1 In standby mode, press and hold PROG/
CLOCK SET for three seconds.
» 
Then the time format [24H] or [12H]
is displayed.
2 Press / to select a time format. Press
PROG/CLOCK SET to store the setting.
» The hour digits blink.
3 Press / to set the hour. Press PROG/
CLOCK SET to store the setting.
» The minute digits blink.
EN