Register your product and get support at MCD2010 www.philips.
1 Important Know these safety symbols Important Safety Instructions Hearing safety Notice 2 Congratulations Feature introduction What’s in the box Overview of the main unit 3 Before use Place the unit Connect Install/replace the battery of remote control 7 Setup 4 4 4 4 5 7 7 7 8 11 11 12 20 20 21 21 21 General setup Video Setup Audio Setup Preference setup 8 Other features 22 22 23 23 23 Set alarm timer Set sleep timer Listen through headphone Listen to external audio device 9 Product information
1 Important Know these safety symbols Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Warning Never remove the casing of this unit. Never lubricate any part of this unit. surface. Never place this unit on other electrical equipment. Only use this unit indoors.
Slowly increase the sound until you can hear it comfortably and clearly, without distortion. Listen for reasonable periods of time: Prolonged exposure to sound, even at normally ‘safe’ levels, can also cause hearing loss. Be sure to use your equipment reasonably and take appropriate breaks. Be sure to observe the following guidelines when using your headphones. Listen at reasonable volumes for reasonable periods of time. Be careful not to adjust the volume as your hearing adapts.
Copyright notice Note The type plate is located on the bottom of the unit. This item incorporates copy protection technology that is protected by U.S. patents and other intellectual property rights of Rovi Corporation. Reverse engineering and disassembly are prohibited. Trademark notice Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories. ‘DVD Video’ is a trademark of DVD Format/ Logo Licensing Corporation.
Congratulations on your purchase, and ! ~ : support that Philips offers, register your product at www.philips.com/welcome. If you contact Philips, you will be asked for the model and serial number of this product. The model number and serial number are on the back of the main unit. Write the numbers here: Model No. __________________________ Serial No.
Overview of the main unit Overview of the main unit n a m b c d e l f g k h i j a Disc compartment Hold the disc. g SOURCE Select a source. b h USB socket. c MP3 LINK Connect external audio device. i d Headphone socket. Turn on the apparatus, switch to standby mode, or Eco Power standby mode. f IR sensor Detect signals from the remote control. Always point the remote control at the IR sensor. 8 EN Start or pause play. Stop play. Erase a program.
E n g lis h l Display panel Show current status. m Open or close the disc tray. n VOLUME Adjust volume. Adjust time. Back view g f a e d b c a SPEAKER OUT Connect the speakers. f AUDIO OUT L/R Audio output jack. b AUX-IN Connect an external audio device. g COAXIAL Coaxial jack. c AC MAIN~ Connected with AC power cord. d FM AERIAL Improve FM reception. e VIDEO OUT Video output jack.
e Overview of remote control a b c r d e AUDIO / SUBTITLE For menus: navigate up/down. Invert a picture. AUDIO: Toggle between stereo and mono. SUBTITLE: Select a subtitle language for a video. f OK g f g h q i p j % / Search in a track or disc. Fast backward or forward. For menus, navigate left/right. Rotate a picture. Return to a previous display menu. Start, pause or resume play.
Stop play. Erase a programed radio station. Activate/deactivate the demonstration mode. q DSC/DBB Select a preset sound setting. Turn on or off dynamic bass enhancement. r MODE/OPTIONS Select repeat play or random play. Accesses options relating to the current activity or selection.
Connect Option 2: Connect through component video cables Connect speakers 1 Insert the speaker wires completely into the speaker input sockets on the back of the unit. Pr/Cr Pb/Cb Note For optimal sound, use the supplied speakers only. Connect only speakers with impedance that is the same or higher than the supplied speakers. ( manual. Connect TV Connect the audio and video cables to the output sockets on the unit and the corresponding input sockets on your TV.
Connect an audio cable to: the AUX IN L/R sockets on this product. the audio output sockets on the external device (for example, audio player). Install/replace the battery of remote control E n g lis h You can route audio from an external device to this product. Caution Risk of explosion! Keep batteries away from AUX OUT % ) \ % Do not mix batteries (old and new or carbon and alkaline, etc).
4 Get started Turn on 1 4 Note The number key on the remote control is deactivated in this mode. Press . » The unit switches to the last selected source. Note Press PROG/CLOCK SET setup. Store radio stations automatically If no source is played within 15 minutes, the unit switches to standby mode. If no operation is performed within 15 minutes in standby mode, the unit switches to Ecopower standby mode. Press to switch the unit to the last source when it was turned off.
This unit is compatible with both NTSC and PAL. If the picture is abnormally displayed with the default setting, select a TV system that :% >( [TV System] details) 5 Play disc/USB E n g lis h Select the correct TV system Caution Risk of damage to the unit! During play, never move the unit. Never put any object other than a disc into the disc compartment.
1 » The user interface is displayed. During play, press SUBTITLE repeatedly. MP3 Note WMA For some DVDs, the language can only be changed from the disc menu. Press DISC MENU to access the menu. Picture 000001 000002 Title: Artist: Album: 000001 000022 00:13/ [ \|Q Q&'Q Y+ are copied onto a CD-R/RW, recordable DVD, or USB storage device.
1 During video/audio play, press / repeatedly to select a search speed. To resume play at normal speed, press . 3 Press , and use ratio. 4 Press OK selection. / to select the right E n g lis h Search forward/backward PBC menu Search by time or title/chapter/track number 1 1 During play, press OPTIONS to access PBC menu. 2 3 4 Use 5 Press OK % » the selected segment is displayed. During video playback, press OPTIONS to access PBC menu.
3 Press , and use options. 4 Press OK selection. to select the sub Rotate picture 1 During play, press / to rotate the picture anti-clockwise/clockwise. Play slideshow and music simultaneously Note Make sure that the USB storage device or the photos. 1 2 3 4 &'Q Y+ &'Q % Access a photo folder. % Press OK to start the slideshow. The slideshow stops after all photos are displayed for one time.
Program radio stations manually E n g lis h 6 Listen to FM radio Note Tune to FM radio stations You can program a maximum of 20 preset radio stations. Note Ensure that you have connected and fully extended the supplied FM antenna. 1 2 3 4 Press FM. Press and hold station. / 1 2 Tune to a radio station. 3 Press / to select a number from 1–20 for this radio station, then press PROG/CLOCK SET to program the current radio station.
» Program type such as [NEWS] (news), [SPORT] (sport), [POP M] (pop music)... » Frequency 7 Setup 1 After you press the button . » The home menu appears. Synchronize clock with RDS station You can synchronize the clock time on the unit with an RDS station. 1 Tune to an RDS radio station that transmits time signals. 2 Press RDS/INFO for over 2 seconds. » [CT SYNC] is displayed and the unit reads RDS time automatically. USB Disc Setup » If no time signal is received, [NO CT] is displayed.
[Sleep Timer]:Sets a sleep timer to switch the home theater to standby % [Auto Standby]:Enables or disables auto standby. If enabled, the home theater switches to standby after 30 minutes of inactivity (for example, in pause or stop mode). [DivX(R) VOD Code]: Get registration code of DivX Video On Demand Registration. audio device that is connected through the analog audio jacks. [Digital Audio]:Select audio formats supported by the connected device.
Note 8 Other features Y < \ % * < \ \ % \ < \ % ‘Movie.srt’. Set alarm timer This unit can be used as an alarm clock. You can select DISC, TUNER or USB as alarm source. Note Make sure that you have set the time correctly. 1 In standby mode, press and hold SLEEP/TIMER for three seconds » [TIMER SET](timer set) scrolls on the display.
1 When the unit is turned on, press SLEEP/TIMER repeatedly to select a time period (in minutes). » When sleep timer is activated, is displayed. » To deactivate sleep timer, press SLEEP/TIMER again until disappears. 9 Product information E n g lis h Set sleep timer Note Product information is subject to change without prior notice. Listen through headphone Region Code Plug a headphone into the You can play DVD discs marked with the following region code. socket.
Audio DAC Total Harmonic Distortion Frequency Response Q X ; < 1% (1 kHz) 4 Hz - 20 kHz (44.1 kHz) 4 Hz - 22 kHz (48 kHz) # ; >X ; ' S/N Ratio Tuner (FM) Tuning Range Tuning grid \ # S/N Ratio \ # S/N Ratio Search Selectivity Total Harmonic Distortion Signal to Noise Ratio 87.
*.PLS, *.WAV Discs recorded in Joliet format MP3 Pro USB playability information Compatible USB devices: ¡ >¡ %J ¡ % ¡ >¡ %J ¡ % memory cards is not compatible with this set. Supported formats: ¡ `': `': File System Audio playback: MP3, WMA Video playback: MPEG4, AVI, DivX 5.0, DivX Ultra+addendium 1.
The aspect ratio of the TV screen cannot be changed even though you have set the TV display format. : < DVD disc. The aspect ratio may not be changed for some TV systems. No sound or poor sound Adjust the volume. Disconnect the headphones. Check that the speakers are connected correctly. Check if the stripped speaker wires are clamped.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. MCD2010_12_UM_V2.
