User manual

13
English
Tip
 In the Eco Power mode, you can press CLOCK to
switch to the standby mode and view the clock (if set).
 If the system remains in the standby mode for more
than 90 seconds, it switches to the Eco Power mode
automatically.
Find the correct viewing
channel
1 Press to turn on the unit.
2 Press DISC to switch to disc mode.
3 Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
 Go to the lowest channel on your TV,
and then press the Channel Down
button until you see the blue screen.
 Press the source button repeatedly on
the remote control of your TV.
Tip
 The video-in channel is between the lowest and highest
channels and may be called FRONT, A/V IN, VIDEO etc.
See the TV user manual on how to select the correct
input on the TV.
Select the correct TV system
Change this setting if the video does not appear
correctly. By default, this setting matches the
most common setting for TVs in your country.
1 Press SYSTEM MENU.
2 Select [Video Setup].
3 Select [TV System] and then press .
4 Select a setting and then press OK.
 [NTSC] - For TV with NTSC color
system.
 [PAL] - For TV with PAL color system.
 [Multi] - For TV that is compatible
with both PAL and NTSC.
5 To exit the menu, press SYSTEM MENU.
2 Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3 Close the battery compartment.
Note
 Before you press any function button on the remote

control.
 If you are not going to use the remote control for a
long time, remove the battery.
Set clock
1 In the Eco Power standby mode, press and
hold CLOCK to activate the clock setting
mode.
» The hour digits are displayed and begin
to blink.
» If the hour digits are not displayed,
press and hold
for 3 seconds to
switch to standby mode, and then
repeat step 1.
2 Press + VOL - to set the hour, and then
press CLOCK again.
» The minute digits are displayed and
begin to blink.
3 Press + VOL - to set the minute.
4 Press CLOCK
Turn on
Press .
» The unit switches to the last selected
source.
Switch to Eco Power standby mode
Press to switch the unit to Eco Power
Standby mode.
» The backlight on the display panel
turns off.
» The blue Eco Power indicator turns on.
EN