Instruction Manual
Table Of Contents
- Important notes for users in the U.K.
- Index
- Contents
- Controls
- CD OPEN-CLOSE (CD 1/CD 2/CD 3) ^
- @ MUTE
- IS (INCREDIBLE SURROUND)
- AUTO REV. (AUTO REVERSE)
- REPEAT
- SHUFFLE
- SLEEP
- RDS
- CLOCK
- Notes for remote control:
- Plug and Play
- Demonstration mode
- Switching the system on
- Switching the system to standby mode
- Switching the system to Eco Power standby mode (< 0.4 Watt)
- Power saving automatic standby
- Dim mode
- Volume control
- Interactive sound control
- Discs for Playback
- Loading disc
- Playing discs
- Selecting a desired track/passage
- Replacing discs during playback
- Repeat and Shuffle
- Programming the disc tracks
- Erasing the programme
- Tuning to radio stations
- Storing preset radio stations
- Tuning to preset radio stations
- Erasing a preset radio station
- RDS
- Loading tape
- Playing tapes
- Rewinding / Fast forwarding
- General information on recording
- Preparation for recording
- One touch recording
- CD Synchronised start recording
- Digital recording via Digital Out
- External Sources
- Maintenance
- Specifications
- Troubleshooting
- 310330618501
Troubleshooting
i
WARNING
Under no circumstances should you try to repair the system yourself, as
this
will invalidate the
warranty. Do not ttpen the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before
tafcing the
system for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or service centre.
Problem
Solution
CD OPERATION
"NO DISC"
is displayed.
—
Insert a disc.
—
Check if the disc is inserted upside dowa
— Wait until the moisture condensation at the lens
has cleared.
— Replace or clean the disc, see "Maintenance".
"DISC NOT FINAL IZED"
is dispiayed.
— Use a finalised CD-RW or CD-R.
RADIO RECEPTION
Radio reception is poor.
— If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
- Increase the distance between the Micro HiR
System and yourTV orVCR.
TAPE OPERATION/RECORDING
Recording or playback cannot be made.
-
Clean deck parts, see "Maintenance".
-
Use only NORMAL (lEC 1) tape.
-
Apply a piece of adhesive tape over the missing
tab space.
The tape deck door cannot open.
— Remove and reconnect the AC power plug and
switch on the system again.
29