Instruction Manual
Table Of Contents
- Important notes for users in the U.K.
- Index
- Contents
- Controls
- CD OPEN-CLOSE (CD 1/CD 2/CD 3) ^
- @ MUTE
- IS (INCREDIBLE SURROUND)
- AUTO REV. (AUTO REVERSE)
- REPEAT
- SHUFFLE
- SLEEP
- RDS
- CLOCK
- Notes for remote control:
- Plug and Play
- Demonstration mode
- Switching the system on
- Switching the system to standby mode
- Switching the system to Eco Power standby mode (< 0.4 Watt)
- Power saving automatic standby
- Dim mode
- Volume control
- Interactive sound control
- Discs for Playback
- Loading disc
- Playing discs
- Selecting a desired track/passage
- Replacing discs during playback
- Repeat and Shuffle
- Programming the disc tracks
- Erasing the programme
- Tuning to radio stations
- Storing preset radio stations
- Tuning to preset radio stations
- Erasing a preset radio station
- RDS
- Loading tape
- Playing tapes
- Rewinding / Fast forwarding
- General information on recording
- Preparation for recording
- One touch recording
- CD Synchronised start recording
- Digital recording via Digital Out
- External Sources
- Maintenance
- Specifications
- Troubleshooting
- 310330618501

Important notes for users in the
U.K.
Madns plug
This apparatus is fitted wHh an approved 13
Amp plug, lb change a fuse in this type of plug
proceed as follows:
1
Remove fuse cover and fuse.
2 Rx new fuse which should be a BS1362 5 Amp,
ASTA, or BSI approved type.
3
Refit the fuse coven
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should
have a value of 5 Amp. If a plug without a fuse
is used, the fuse at the distribution board
should not be greater than 5 Amp.
Note: The severed plug must be disposed of to
avoid a possible shock hazard should ft be
inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with
the following code: blue — neutral (N),
brown = live (L).
• As these colours may not correspond with the
colour markings identifying the terminals in
your plug, proceed as follows:
— Connect the blue wire to the terminal
marked N or coloured black.
— Connect the brown wire to the terminal
marked L or coloured red.
— Do not connect either wire to the earth
terminal in the plug, marked E (or 4^) or
coloured green (or green and yellow).
Before replacing the plug cover, make certain
that the cord grip is clamped over the sheath
of thè lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may
require consent See Copyright Act 1956 and
The Performer's Protection Acts 1958 to 1972.
Italia
DICHIARAZIONE DI CONFORMITÀ*
Si dichiara che l'apparecchio MC-77 Philips
risponde alle prescrizioni dell'ai-t 2 comma 1 del
D.M. 28 Agosto 1995 n. 548.
Fatto a Eindhoven
Philips Consumer Bectronics
Philips, Glaslaan 2
5616 JB Eindhoven,The Netherlands
r
Norge
Typeskilt finnes pà apparatens baksìde.
Observer;
Nettìtryteren
e'r sekundert
innkoplet.
Oen
innebygde
netde/en er
derfor
ikke frakoplet
nettet
sà lenge
apparatet er tikluttet
nettkontokten.
For à redusere faren for brann eller elektrisk
slot skal apparatet ikke utsettes for regn eller
fliktighet
CAUTION
Use of
controls or adjustments or
performance of procedures other than
herein may result in hazardous
radiation exposure or other unsafe
operation.










