Register your product and get support at www.philips.
Contents 1 Important Safety Notice 2 Your Micro Hi-Fi System Introduction What's in the box Overview of the main unit Overview of the remote control 4 4 6 7 7 7 8 9 8 Other features 16 16 16 16 Set the alarm timer Set the sleep timer Listen to an external device 9 Product information 17 17 Maintenance 10 Troubleshooting 3 Get started Connect speakers Connect power Prepare the remote control Set clock Turn on 4 Play Play disc Skip to a track Search within a track Repeat play Random pl
1 Important Safety Know these safety symbols g Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or produce heat. i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
& & & Do not mix batteries (old and new or carbon and alkaline, etc.). Remove batteries when the unit is not used for a long time. Batteries (battery pack or batteries installed) shall not be exposed to * ; % the like. o Apparatus shall not be exposed to dripping or splashing.
To establish a safe volume level: & Set your volume control at a low setting. & Slowly increase the sound until you can hear it comfortably and clearly, without distortion. Listen for reasonable periods of time: & Prolonged exposure to sound, even at normally 'safe' levels, can also cause hearing loss. & X G $ ! G and take appropriate breaks. Be sure to observe the following guidelines when using your headphones. & Listen at reasonable volumes for reasonable periods of time.
The making of unauthorized copies of copyprotected material, including computer H % % ! recordings, may be an infringement of copyrights and constitute a criminal offence. $ ! purposes. 2 Your Micro HiFi System Congratulations on your purchase, and # \ ] G ! support that Philips offers, register your product at www.philips.com/welcome.
Overview of the main unit a b c h d i j e k l f m g a PULL TO OPEN & Open or close the disc compartment. b STANDBY-ON & Turn on the unit, or switch to standby. c iR & Remote sensor. 8 EN d SOURCE & Select a source: disc, tuner, tape or AUX (external audio source). e PRESET +/& Select a preset radio station.
f DBB & Turn on or off dynamic bass enhancement. g Tape deck operation & Start to record. & Start tape play. & / Fast rewind/wind the tape. Stop the tape play or open the tape door. & Pause tape play or pause recording. h TUNING / & Skip to a previous or next track. & Search within a track or disc. & Tune to a radio station. VOL +/& Adjust volume. Overview of the remote control g a b c h i d j k e l m f n o i & Start or pause play. j REPEAT & Repeat a track or disc. k PROG & Program tracks.
f PRESET +/& Select a preset radio station. 3 Get started g POWER & Switch on the unit & Switch to standby. h SLEEP & Set the sleep timer. i CLOCK/DISPLAY & Set the clock. & Display play information. j TIMER & Set the alarm timer. Caution & Use the controls only as stated in this user manual. & Always follow the instructions in this chapter in $ < Connect speakers k & Start or pause play. / & Search within a track or disc. & Tune to a radio station. / & Skip to a previous or next track.
Prepare the remote control Caution & Risk of explosion! Keep batteries away from heat, < ; ! < 3 Insert the black wire into the black (-) socket. 4 ` % main unit marked 'LEFT'. 5 Repeat steps 2-3. To insert the remote control battery: 1 2 Open the battery compartment. 3 Close the battery compartment. Insert 2 AAA batteries (not supplied) with correct polarity (+/-) as indicated.
3 Press PROG repeatedly to select 12 hour or 24 hour format. 4 Press CLOCK/DISPLAY < » The hour digits are displayed and begin to blink. 5 Press / (or TUNING the main unit) to set the hour. 6 Press CLOCK/DISPLAY < » The minute digits are displayed and begin to blink. 1 2 Press DISC to select the disc source. 7 Press / (or TUNING / the main unit) to set the minute. 3 8 Insert a disc with the printed side facing up, then close the disc compartment.
Random play 1 During play, press SHUF. » } ~` = G are played randomly. 2 To return to normal play, press SHUF again. Note & Random play cannot be selected when you play 5 Adjust volume level and sound effect Adjust volume level programmed. 1 Program tracks You can program a maximum of 20 tracks. 1 At CD mode, in the stop position, press / to select a track number. 2 Press PROG < » [PROG] (program) blinks on the display.
6 Listen to radio 2 Press PROG to activate program mode. » [PROG] blinks on the display. 3 Press PRESET +/- to allocate a number to this radio station, then press PROG to < » ! $ G of the preset station are displayed. 4 Repeat the above steps to program other stations. Tune to a radio station 1 2 Press TUN to select radio source. Press and hold / for more than 2 seconds. » [SEARCH] (search) is displayed.
7 Listen to tape 6 Note Press to start recording. » Disc play starts automatically from the beginning of the disc or the selected section. & & & When you play or record a tape, the sound source To pause or resume recording, press . . To stop recording, press cannot be changed. & To record, use only "Normal" (IEC type I) tapes on which the write-protect notches (tabs) are not broken. Record from radio to tape Tune to a radio station. Play a tape 1 2 1 2 Press TAPE to select the tape source.
8 Other features Note & Alarm timer is not available in AUX mode. & If disc or tape source is selected and the track or tape cannot be played, tuner is activated automatically. Set the alarm timer This unit can be used as an alarm clock. The disc or tuner is activated to play at a preset time. Set the sleep timer 1 Make sure that you have set the clock correctly. This unit can switch to standby automatically after a set period of time. 2 Press POWER to switch the unit to standby.
9 Product information Note & Product information is subject to change without prior notice. General information AC power Operation Power Consumption Standby Power Consumption Dimensions - Main Unit (W x H x D) Weight (with/without speakers) 230 - 240V, 50Hz 15W <2W 148 x 233 x 216 mm approximately 3.65/1.
Clean the heads and the tape paths & H H G $ G% clean the heads A, the capstan(s) B, and pressure roller(s) C after every 50 hours of tape operation. & Use a cotton swab slightly moistened with H = < & You can also clean the heads by playing a cleaning tape once. Demagnetise the heads & Use a demagnetising tape available at your dealer. 10 Troubleshooting Caution & Never remove the casing of this apparatus.
& & & & Reduce the distance between the remote control and the unit. Insert the battery with its polarities (+/– signs) aligned as indicated. Replace the battery. Aim the remote control directly at the sensor on the front of the unit. No disc detected & Insert a disc. & Check if the disc is inserted upside down. & Wait until the moisture condensation at the lens has cleared. & Replace or clean the disc.
Specifications are subject to change without notice © 2011 Koninklijke Philips Electronics N.V. All rights reserved. MC147_UM_05_V1.
