MC-10 Micro HiFi System 1 pg 001-020/MC10/22-Eng 1 12/7/00, 1:29 PM 3140 115 27752
pg 001-020/MC10/22-Eng 2 12/7/00, 1:29 PM 3140 115 27752
% OPEN • CLOSE $ 3 1 2 CD STANDBY ON PROGRAM TIMER PROGRAM PROGRAM 4 TIMER ON • OFF SELECT SOURCE DSC DBB INCREDIBLE SURR.
Important notes for users in the U.K. 1 2 3 Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Remove fuse cover and fuse. Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type. Refit the fuse cover. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp.
English Index Français English ------------------------------------------------ 6 Español Français -------------------------------------------- 21 Deutsch Español --------------------------------------------- 36 Nederlands Deutsch --------------------------------------------- 51 Italiano Nederlands ---------------------------------------- 66 Svenska Italiano ---------------------------------------------- 81 Dansk Svenska --------------------------------------------- 96 Suomi Dansk ---------
Contents English General Information Maintenance .............................................. 17 Environmental Information ................................ 7 Supplied Accessories ........................................... 7 Safety Information ................................................ 7 Clock/Timer Preparation Rear Connections ............................................. 8-9 Inserting batteries into the Remote Control 9 Setting the clock .................................................
¶ The type plate (which contains the serial number) is located at the rear of the system. ¶ Recording is permissible if copyright or other rights of third parties are not infringed. ¶ This product complies with the radio interference requirements of the European Community. Environmental Information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).
Preparation English A R L speaker 8Ω + AM aerial RIGHT – – LEFT + FM aerial 75Ω B AUX in L R C E D Rear Connections A AM Loop Antenna Connection Connect the supplied loop antenna to the AM ANTENNA terminal. Place the AM loop antenna far away from the system and adjust its position for the best reception. B FM Wire Antenna Connection Connect the supplied FM wire antenna to the FM AERIAL (FM ANTENNA) 75 Ω terminal. Adjust the position of the FM antenna for the best reception.
D Connecting other equipment to your system You can connect the audio left and right OUT terminals of a TV, VCR, Laser Disc player, DVD player or CD Recorder to the AUX IN terminals at the rear of the system. English Preparation Inserting batteries into the Remote Control ¶ Insert batteries (Type R06 or AA) into the remote control as shown in the battery compartment. + - After all other connections have been made, connect the AC power cord of the system to the wall outlet.
Controls English @ Mode Selection # $ – % – ^ – & – * – STOP 9 ............ stops CD playback or erase a CD programme. PLAY•PAUSE ÉÅ ( É, SIDE/Å )…starts or interrupts CD play. PRESET 43 ( ¡, ™ ) .............. selects a preset radio station. PREV ¡1 / NEXT 2™ ( ¡, ™ ) ................ skips to the beginning of a current track/previous/ subsequent track. ( à, á ) .......... fast searches back and forward within a track/CD. TUNING à á ( à, á ) .......... tunes to radio stations.
Adjusting volume and sound CD STANDBY ON PROGRAM TIMER 1 Turn the VOLUME control anti-clockwise to decrease or clockwise to increase volume on the system (or press VOLUME -/+ on the remote control). ➜ Display shows the volume level VOL and a number from 0-32. 2 Press the Interactive sound control, DSC on the system or remote control once or more to select the desired sound effect: OPTIMAL (no indication)/ ROCK ( ) / JAZZ ( )/ POP ( ) . 3 Press DBB to switch bass enhancement on or off.
Compact Disc English ➜ The display freezes and the elapsed playing time flashes when playback is interrupted. CD STANDBY ON 6 PROGRAM PROGRAM TIMER Note: CD play will also stop when; – the CD door is opened. – the disc has reached the end. – you select another source: TAPE,TUNER or AUX. – you select to standby. – you press the tape deck PLAY 2 key. ON • OFF SELECT SOURCE DSC DBB INCREDIBLE SURR.
1 2 To select your play mode, press the SHUFFLE or REPEAT button before or during playback until the display shows the desired function. Press PLAY•PAUSE 2; (on the remote control 2) to start playback if in the STOP position. ➜ If you have selected SHUFFLE, playback starts automatically. 3 To return to normal playback, press the respective SHUFFLE or REPEAT button until the various SHUFFLE/ REPEAT modes are no longer displayed. ¶ You can also press STOP 9 to cancel your play mode.
Tuner English 2 TUNER PROGRAM TIMER STANDBY ON PROGRAM TIMER SELECT SOURCE ON•OFF DSC DBB INCREDIBLE SURR. Press PROGRAM on the system or remote control for more than 2 seconds to activate programming. ➜ AUTO is displayed and available stations are programmed in order of waveband reception strength: FM followed by MW and LW. The last preset automatically stored will then be played.
Note: – If you press RDS and the RDS signal is not available NO RDS is displayed. RDS News and Traffic Announcement (TA) You may set up the tuner in such a way that listening to CD or tape is interrupted by the NEWS of a RDS station. This only works if the RDS station broadcasts a NEWS signal while sending the news. EON Enhanced Other Network allows you to search for an RDS station offering a certain programme type. If EON is available, is shown.
Tape Recorder English General Information on Recording INCREDIBLE SURROUND RECORD PLAY STOP • OPEN PAUSE Tape playback 1 Select TAPE source. ➜ The display shows TAPE throughout tape operation. 2 3 Press STOP•OPEN to open the tape door. 4 5 Press PLAY 2 to start playback. 6 By pressing à or á on the system fast winding of tape is possible in both directions. 7 To stop the tape, press STOP•OPEN. Insert a recorded tape and close the tape door.
7 To stop recording, press STOP•OPEN. Recording from the Radio 1 Tune to the desired radio station (see Tuning to radio stations). 2 3 Press STOP•OPEN to open the tape door. 4 5 Press RECORD to start recording. 6 To stop recording, press STOP•OPEN. English Tape Recorder Recording from AUX 1 2 Select AUX source. 3 Press RECORD to start recording. If necessary, prepare the additional appliance for recording. Insert a suitable tape into the deck and close the tape door.
Clock/Timer English Setting TIMER CD STANDBY ON PROGRAM TIMER PROGRAM TIMER SELECT SOURCE ON•OFF DSC DBB INCREDIBLE SURR. INTERACTIVE SOUND VOLUME iR SENSOR STOP PRESET PLAY•PAUSE RDS CLOCK PREV REPEAT TUNING ¶ The system can be used as an alarm clock, whereby the CD or TUNER is switched on at a set time. The clock time needs to be set first before the timer can be used. ¶ During setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically.
Activating and deactivating SLEEP The sleep timer enables the system to switch off by itself after a set period of time. The clock time needs to be set first before the sleep timer can be used. ¶ To deactivate, press SLEEP on the remote control once or more until SLEEP OFF is shown, or press STANDBY ON on the system or remote control. ➜ SLEEP OFF scrolls across the display. TUNER ¶ Press SLEEP on the remote APE control once or more. SLEEP ➜ Display shows SLEEP and UX one of the sleep time options SC INC.
Troubleshooting English WARNING Do not open the system as there is a risk of electric shock! Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty ¶ If a fault occurs, first check the points listed below before taking the system for repair. ¶ If you are unable to remedy a problem by following these hints, consult your dealer or service centre. Symptom Remedy CD PLAYER OPERATION “NO DISC” is displayed. ¶ Check if the disc is inserted upside down.
