Operation Manual

31
Service code
! Only use this function when absolutely necessary. If
you are satisfied with your changes to the factory
settings you should not use this function.
Function 45 (Service code) is used to delete some or all of your changes
to the factory settings. This function enables you to partially or fully
reconfigure your device. It is especially helpful if you have modified
settings but find that your fax machine does not respond as expected.
After deleting some or all of your custom settings please rerun EASY
INSTALL.
The following codes are at your disposal:
Code No. 7117
This code erases all your modifications to the factory settings. The fax
machine will therefore react in exactly the same way as on first installa-
tion.
Code No. 7140
When you enter this code, all your entered settings and data will be
erased, except for:
• your personal outgoing message on your built-in answering machine
• received messages
• stored short dial numbers
• stored telephone book numbers
• your name
• your telephone number
Example for using a service code:
1 Select function 45 and enter the service code (7117 or 7140).
Press OK.
2 With </> you can select whether you really want to delete your
settings. Confirm with OK. Your fax machine will be reset to its
original configuration.
Care and maintenance
instructions
The scanner glass and rollers of your fax machine should be cleaned of
paper dust and scuff when necessary.
! Before opening the fax machine, make sure that
you are electrically discharged by e.g. touching the
metal housing of a grounded appliance, a water
pipe or radiator.
! Use a soft, fluff-free cloth lightly moistened with a
little alcohol (96%). You can also use a special
cloth for cleaning fax machines, which is available
on the market. Do not allow any moisture to
penetrate inside the device.
Fouling by copying or
sending fax messages
Clean the scanner glass, scanner roller, docu-
ment feed roller and facing rubber lips
1 Open the operation panel by raising it at the recess in the middle. If
you hear a slight click, the panel is latched into place.