Operation Manual

11
User Manual
If the message INKFILM LOW appears on the display,
there is not much ink film remaining. However, you
can still print out a few more pages.
If the ink film is finished or if there is no ink film in
the fax machine, the red display lamp flashes, and the
following message appears: REFILL INKFILM.
1 Before loading a new ink film you must remove the
paper from the paper feed mechanism! Also follow
the instructions on your ink film packaging!
2 Open the fax machine by lifting the operating panel
in the middle until it clicks in place.
v For use with Philips ink films only!
Removing the ink lm
1 Lift the rear ink film roll holding both sides with
your index fingers upwards, in order to remove it
out of its seat and place it next to the front ink film
roll.
2 Remove both ink film rolls. They cannot be reused.
3 Remove the old Plug’n’Print card from the slot to
the left of the ink film compartment (only the initial
free ink film does not have a Plug’n’Print card).
Loading the ink lm
1 Carefully remove the rubber rings from the new ink
film. Take care not to damage the ink film.
2 Lay the large roll in the grooves provided in the
rear ink film compartment. The blue toothed wheel
must be on the right-hand side.
3 Now take the small roll and lay it in the front ink
film compartment. Make sure that the blue toothed
wheel is on the right and the pin on the left is in-
serted in the depressions.
4 Turn small roll forward to tension the ink film.
Make sure that the ink film is not creased.