Technical data

31EN
2 Select [Services] > [Call barring] >
[Change PIN], then press MENU/OK to
conrm.
3 Enter the old barring PIN/passcode. The
default PIN is 0000. Then press MENU/OK
to conrm.
4 Enter the new PIN/passcode, then press
MENU/OK to conrm.
5 Enter the new PIN/passcode again, then
press MENU/OK to conrm.
» The setting is saved.
Blacklist
You can put numbers into the blacklist to block
incoming calls to certain undesirable numbers.
You can create 4 sets of numbers with 24 digits
at maximum for each set of numbers. When
there is an incoming call that starts with one
of these 4 sets of numbers, the ringer will be
muted.
Note
• Make sure you have subscribed to the caller ID service
before you use this feature.
• The contact's name in phonebook will not be displayed
if this contact's number matches the record saved in
the blacklist.
Activate/deactivate the blacklist
1 Press MENU/OK.
2 Select [Services] > [Blacklist], then press
MENU/OK to conrm.
3 Select [Blacklist mode], press MENU/OK
to conrm.
4 Enter the PIN/passcode. The default PIN is
0000. Then press MENU/OK to conrm.
5 Select [On]/[Off], then press MENU/OK
to conrm.
» The setting is saved.
Add blacklist numbers
1 Press MENU/OK.
2 Select [Services] > [Blacklist], then press
MENU/OK to conrm.
3 Select [Blacklist], then press MENU/OK
to conrm.
4 Enter the PIN/passcode. The default PIN is
0000. Then press MENU/OK to conrm.
5 Enter the number, then press MENU/OK
to conrm.
» The setting is saved.
Change the blacklist PIN/passcode
1 Press MENU/OK.
2 Select [Services] > [Blacklist]> [Change
PIN], then press MENU/OK to conrm.
3 Enter the old barring PIN/passcode. The
default PIN is 0000. Then press MENU/OK
to conrm.
4 Enter the new PIN/passcode, then press
MENU/OK to conrm.
5 Enter the new PIN/passcode again, then
press MENU/OK to conrm.
» The setting is saved.
Network type
Note
• This is a country dependent feature. It only applies to
models with network type support.
1 Press MENU/OK.
2 Select [Services] > [Network type], then
press MENU/OK.
3 Select a network type, then press MENU/
OK.
» The setting is saved.