Technical data

29EN
Note
• The remote access PIN code is the same as your
system PIN. The preset PIN is 0000.
Activate/deactivate the remote access
You can allow or block remote access to the
answering machine.
1 Press / or MENU/OK > [Answ.
Machine] > MENU/OK.
2 Select [Remote access], then press
MENU/OK to conrm.
3 Select [Activate]/[Deactivate], then press
MENU/OK to conrm.
» The setting is saved.
Change the PIN/passcode
1 Press / or MENU/OK > [Answ.
Machine] > MENU/OK.
2 Select [Remote access] > [Change PIN],
then press MENU/OK to conrm.
3 Enter the old PIN/passcode, then press
MENU/OK to conrm.
4 Enter the new PIN/passcode, then press
MENU/OK to conrm.
5 Enter the new PIN/passcode again, then
press MENU/OK to conrm.
» The setting is saved.
Access the answering machine
remotely
1 Make a call to your home number with a
touch tone phone.
2 Enter # when you hear the announcement.
3 Enter your PIN code.
» You now have access to your
answering machine, and you can now
listen to the new messages.
Note
• You have 2 chances to enter the correct PIN code
before your phone hangs up.
4 Press a key to carry out a function. See the
Remote access commands table below for
a list of available functions.
Note
• When there is no message, the phone hangs up
automatically if no key is pressed for 8 seconds.
Remote access commands
Key Function
1 Listen to the previous message.
2 Listen to messages.
3 Skip to the next message.
6 Delete the current message.
7 Switch the answering machine on
(not available when you listen to the
messages).
8 Stop listening to the message.
9 Switch the answering machine off.
(not available when you listen to the
messages).
Behavior of the LED indicator on the
base station
The table below shows you the current status
with different LED indicator behavior on the
base station.
LED
indicator
Message status
Steady on You are in a call.
Flashing • There is a new message.
• There is a new voice mail.
• There is a missed call.
• There is an incoming call.
• The system is in registration
mode.