Short user manual Mira Design cordless phone (M560) Design cordless phone with answering machine (M565) Register your product and get support at www.philips.
Important safety instructions Warning • The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible. • Refer to safety information before using the product. • This product complies with European RE directive 2014/53/EU. • Use only the power supply listed in the user instructions. • Use only the batteries listed in the user instructions.
Overview 1 Standby In call Access the main menu. Access the redial list. Access the redial list. Confirm / Select / Enter the option menu. Adjust the volume. Phonebook Cancel / back Recall (network dependent). Call log Up / down End calls. Make and receive calls. Exit menu. Enter a pause (press and hold). Switch the handset on or off (press and hold). Turn the speaker on/off. / In menu Phonebook Make intercom call (press and hold). Mute/unmute the microphone.
2 Connect 1 2 3 Multi-handset version only.
3 Get started Configure your phone 1 The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. 2 When using your phone for the first time, you see a welcome message (country dependent). 3 Set the country and language if prompted. 4 Set the date and time. • If the time is in 12-hour format, press / to select [am] or [pm] (country dependent). Charge your phone Charge 8 hours Charge your handset by docking it in either direction.
4 Enjoy Phonebook Add record 1 Press . 2 Select [Phonebook] > [Add new]. 3 Follow on-screen instructions. Call from the phonebook 1 Press . 2 Select a record and press . Direct access memory You have up to 2 direct access memories (keys 1 and 2). To dial the saved phone number automatically, press and hold on the keys in standby mode. Depending on your country, keys 1 and 2 are preset to the voice mail number and information service number of your service provider respectively (network dependent).
Technical data Battery • Philips: 2 x AAA NiMH 1.2 V Rechargeable 500 mAh batteries Use only the supplied batteries. Adapter (base and charger) Tenpao: S003GB0600050 Input: 100-240 V~ 50/60 Hz 150 mA Output: 6 Vdc 500 mA Phonebook with 100 entries Call log with 50 entries Talk time: 16 hours Standby time: 250 hours RF output power: < 24 dBm Frequency band: 1880 MHz - 1900 MHz Note You can find the Declaration of Conformity on www.p4c.philips.com.
Frequently asked questions No signal bar is displayed on the screen. • The handset is out of range. Move it closer to the base station. • If the handset displays [Unregistered], register your handset. (See the section on “Register additional handsets”). If I fail to pair (register) the additional handsets to the base station, what do I do? > • Your base memory is full. Access [Services] > [Unregister] to unregister the unused handsets and try again.
www.philips.com/support To access the user instructions online, use the reference model number written on the product label at the bottom of the base station.
This symbol on a product means that the product is covered by European Directive 2012/19/EU. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. UMS_M560/565 05_EN_v1.
