Register your product and get support at www.philips.
Important safety instructions Warning • The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible. • Refer to safety information before using the product. • This product complies with European R&TTE directive 1999/5/EC • Use only the power supply listed in the user instructions. • Use only the batteries listed in the user instructions.
Overview 1 Earpiece Loudspeaker (back of the handset) Display icons Microphone In call Phonebook Access the redial list. Increase the volume. Decrease the volume. End calls. Turn the speaker on/off. Mute/unmute the microphone. Enter a pause (press and hold). Standby Access the main menu. Access the redial list. Phonebook Call log Make and receive calls. Make an intercom call (press and hold). For multi-handset version only. Switch the handset on or off (press and hold).
2 Connect 2 1 3 Multi-handset version only.
3 Get started Configure your phone 1 The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. 2 When using your phone for the first time, you see a welcome message (country dependent). 3 Set the country and language if prompted. 4 Set the date and time. • If the time is in 12-hour format, press / key to select [am] or [pm] (country dependent). Charge your phone Charge 8 hours Charge your handset by docking it in either direction.
4 Enjoy Phonebook Add record 1 Press > [Phonebook] > [Add new]. 2 Follow on-screen instructions. Call from the phonebook 1 Press . 2 Select a record and press . Direct access memory You have 2 direct access memories (Keys 1 and 2). To dial the saved phone number automatically, press and hold on the keys in standby mode.
Technical data Battery • Philips: 2 x AAA NiMH 1.2V Rechargeable 550mAh batteries Use only the supplied batteries. Adapter Base Charger Philips S003EB06000302 S003IB0600040 Input: 100-240Vac 100-240Vac 50/60Hz 0.2A 50/60Hz 0.15A Output: (i) 6Vdc 0.3A 6Vdc 0.4A (ii) 6Vdc 0.2A Phonebook with 100 entries Call log with 50 entries Talk time: 16 hours Standby time: 250 hours Note • You can install a DSL (digital subscriber line) filter to prevent noise and caller ID problems caused by the DSL interference.
Frequently asked questions No signal bar is displayed on the screen. • The handset is out of range. Move it closer to the base station. • If the handset displays [Register your handset], register your handset. (See the section on Register the hands). If I fail to pair (register) the additional handsets to the base station, what do I do? Your base memory is full. Access > [Services] > [Register your handset] to unregister the unused handsets and try again.
www.philips.com/support For information, refer to the extended user documentation online.
0168 This symbol on a product means that the product is covered by European Directive 2012/19/EU. 2015 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. ums_M550-555 05_EN_V3.
