Register your product and get support at www.philips.
Important safety instructions Warning • The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible. • Refer to safety information before using the product. • Hereby, Gibson Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
1 Overview In call Enter the option menu. Access the redial list. Adjust the volume. Standby Access the main menu. Access the redial list. Phonebook Recall (network dependent). Call log End calls. Enter a pause (press and hold). Turn the speaker on/off. Make and receive calls. Switch the handset on/off (press and hold). Make intercom call (press and hold). Lock/unlock the keypad (press and hold). Make and receive calls through the speaker. Mute/unmute the microphone.
2 Connect 1 2 3 Multi-handset version only.
3 Get started Configure your phone Charge your phone 1 The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. 2 When using your phone for the first time, you see a welcome message (country dependent). 3 Set the country and language if prompted. 4 Set the date and time. • If the time is in 12-hour format, press / to select [am] or [pm] (country dependent).
4 Enjoy Phonebook Add record 1 Press . 2 Select [Phonebook] > [Add new]. 3 Follow on-screen instructions. Call from the phonebook 1 Press . 2 Select a record and press . Direct access memory You have 2 direct access memories (Keys 1 and 2). To dial the saved phone number automatically, press and hold on the keys in standby mode. Depending on your country, keys 1 and 2 are preset to the voice mail number and information service number of your service provider respectively. (network dependent).
Technical data Battery • Philips: 2 x AAA NiMH 1.2 V Rechargeable 550 mAh batteries Use only the supplied batteries.
Frequently asked questions No signal bar is displayed on the screen. • The handset is out of range. Move it closer to the base station. • If the handset displays [Unregistered], register your handset (see the section on “Register additional handsets”). If I fail to pair (register) the additional handsets to the base station, what do I do? Your base memory is full. Access > [Services] > [Unregister] to unregister the unused handsets and try again.
www.philips.com/support To access the user instructions online, use the reference model number written on the product label at the bottom of the base station.
2017 © Gibson Innovations Limited. All rights reserved. This symbol on a product means that the product is covered by European Directive 2012/19/EU. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. UMS_M330/M335 05_EN_v4.
