Register your product and get support at www.philips.
Important safety instructions Warning • The Electrical network is classified as hazardous. The only way to power down the charger is to unplug the power supply from the electrical outlet. Ensure that the electrical outlet is always easily accessible. • Refer to safety information before using the product. • Hereby, Gibson Innovations declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
1 Overview In call Phonebook Access the redial list. Adjust the volume. Recall (network dependent). End calls. Enter a pause (press and hold). Turn the speaker on/off. Mute/unmute the microphone. In menu Confirm / Select / Enter the option menu. Cancel / back Up / down Exit menu. Standby Access the main menu. Access the redial list. / Switch the ambient light on/off (press and hold). Phonebook Call log Make and receive calls. Switch the handset on/off (press and hold).
Connect 2 1 2 3 Multi-handset version only.
3 Get started Configure your phone 1 The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. 2 When using your phone for the first time, you see a welcome message (country dependent). 3 Set the country and language if prompted. 4 Set the date and time. / • If the time is in 12-hour format, press to select [am] or [pm] (country dependent).
4 Enjoy Phonebook Add record 1 Press . 2 Select [Phonebook] > [Add new]. 3 Follow on-screen instructions. Call from the phonebook 1 Press . 2 Select a record and press . Direct access memory You have 2 direct access memories (Keys 1 and 2). To dial the saved phone number automatically, press and hold on the keys in standby mode. Depending on your country, keys 1 and 2 are preset to the voice mail number and information service number of your service provider respectively. (network dependent).
Technical data Battery • Philips: 2 x AAA NiMH 1.2 V Rechargeable 550 mAh batteries Use only the supplied batteries. Adapter (base and charger) Input: Output: MEIC: 100-240 V~ 6 Vdc MN-A102-U130 50/60 Hz 200 mA 400 mA Tenpao: 100-240 V~ 6 Vdc S003IB0600040 50/60 Hz 150 mA 400 mA P/N: R017886V-B Phonebook with 50 entries Call log with 20 entries Talk time: 16 hours Standby time: 180 hours RF output power: <24 dBm Frequency Band: 1880 MHz ~ 1900 MHz Note • You can find the Declaration of Conformity on www.
Frequently asked questions No signal bar is displayed on the screen. • The handset is out of range. Move it closer to the base station. • If the handset displays [Unregistered], register your handset (see the section on “Register additional handsets”). If I fail to pair (register) the additional handsets to the base station, what do I do? Your base memory is full. Access > [Services] > [Unregister] to unregister the unused handsets and try again.
www.philips.com/support To access the user instructions online, use the reference model number written on the product label at the bottom of the base station.
2017 © Gibson Innovations Limited. All rights reserved. This symbol on a product means that the product is covered by European Directive 2012/19/EU. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. UMS_M345 05_EN_v2.
