Software Upgrade

3
3. Select the unzipped files from the browser on top.
4. Click “Add” to copy the files below.
5. Select “Record CD” in the „File‟ menu.
6. Click “Start Recording”, the firmware upgrade will now be burned onto the disc.
Apply Upgrade to your Set
1. Power up the set and insert the prepared Upgrade CDR.
2. The set will automatically start upgrading.
3. Set‟s FTD will display ERASE, after which the glass door will open. Remove Disc from set.
DO NOT close the glass door.
4. FTD
1
will show WRITE -> UPG END in about 4-5 minutes time.
5. The glass door will automatically close and the set will go to standby. Software upgrading is completed
*Please do not interrupt the upgrading process by powering off the set. If after 20 minutes of upgrading, the tray
door is still OPEN, please call service center for assistance.
1
When the Glass door is fully opened, FTD will be blocked, but the set is still upgrading the SW and the door
will close automatically after the upgrade ends.
Your product is successfully upgraded!
Verifying firmware version
To check the firmware version, see Step 1.
Step 4
Step 5