User Manual

ManualsBrandsPhilips ManualsVideoHTS6600-37

Table Of Contents

Firmware Upgrade

Introduction

The upgrade version of this software is Version 34 and can be used to upgrade Philips HTS6600/37 to the latest

status.

This upgrade allows the HTS6600 to improve the following:

1. Improved picture quality

Upgrade Procedure

Ste

Check your current firmware version

1 Power up the set and eject the disc tray, then press <DISPLAY> button on the remote control.

2 The software version and other information are display on the TV screen as follows:

SD9.2-VXX 6600-XX X

Servo : XXXXXXXX Reg:X

Example :

SD9.2-V33 6600-12 2 -> Indicates Software version 34, stroke version 37, Default Stroke Version region 2.

Servo : D1580000 Reg:2 -> Indicates Servo version D1580000 and Region code 2.

Note:

Do NOT upgrade your set if the software version number is higher than V34!

The firmware information is also useful when you call Philips Customer Care Center.

Ste

Download Firmware upgrade

1 Check you have the following tools:

• PC (Pentium III 300MHz processor or higher)

• CD-R/RW writer and writing application software

• Blank CD-R or CD-RW disc

• Internet access (broadband or high speed)

2 Click the link to download Firmware Upgrade to your PC

3 Unzip the .zip file

i) Do not rename the filename.

ii) Visit

http://www.winzip.com/ for downloads if you cannot open the .zip file.

Ste

Burning Upgrade on CD-R / CD-RW

1 Extract the files by unzipping the zipped file.

2 Write the extracted files – not the zip file – onto a blank CD-R or CD-RW disc, using the following settings:

- File System CD-ROM Joliet

Tip: For more information on

burning software we suggest you

can refer to two popular burning

software programs

www.nero.com

www.eas

cdcreator.com

- File name length : max 31 chars (ISO Level 2)

- Mode : 2/XA

- Character set : ISO 9660

- Single session

- Write Speed : Low

3 Finalize the disc. (The application may do this automatically.)

Summary of content (3 pages)

PAGE 1
Firmware Upgrade Introduction The upgrade version of this software is Version 34 and can be used to upgrade Philips HTS6600/37 to the latest status. This upgrade allows the HTS6600 to improve the following: 1. Improved picture quality Upgrade Procedure Step 1 Check your current firmware version 1 2 Power up the set and eject the disc tray, then press button on the remote control. The software version and other information are display on the TV screen as follows: SD9.
PAGE 2
Using Nero Express 6 Please make sure you are using Nero Express. You can start Nero Express from the Nero folder in Windows Start menu. 1. Insert a blank CD-R or CD-RW disc. 2. Open Nero Express and select “Data disc”. 3. Click on the “Add” 4. Select the unzipped files 5. Click “Add” and “Finished”. 6. Click on “Next” and follow by “Burn”. The firmware upgrade will now be burned onto the disc. tab to browse. Using Easy CD Creator 1. Insert a blank CD-R or CD-RW disc 2.
PAGE 3
Step 4 Apply Upgrade to your Set 1. 2. 3. 4. Power up the set and insert the prepared Upgrade CDR. The set will automatically start upgrading. Set’s FTD will display ERASE, after which the tray door will open. Remove Disc from set. DO NOT close the tray door. The tray door will automatically close and the set will go to standby. Software upgrading is completed. *Please do not interrupt the upgrading process by powering off the set.