Software Upgrade

Firmware Upgrade

Introduction

The upgrade version of this software is Version 35 and can be used to upgrade Philips

HTS6600/12 and HTS6600/05 to the latest status.

This upgrade allows the HTS6600 to improve the following:

1. Improved picture quality

Note: This upgrade is not applicable for the HTS6600 sets that support 1080p, i.e. with serial

number starting with VN2A or NW2A.

Upgrade Procedure

Check your current firmware version

1 Power up the set and eject the disc tray, then press <DISPLAY> button on the remote

control.

2 The software version and other information are display on the TV screen as follows:

SD9.2-VXX 6600-XX X

Servo : XXXXXXXX Reg:X

Example :

SD9.2-V35 6600-12 2 -> Indicates Software version 35, stroke version 12, Default Stroke Version

region 2.

Servo : D1580000 Reg:2 -> Indicates Servo version D1580000 and Region code 2.

Note:

Do NOT upgrade your set if the software version number is higher than V35!

The firmware information is also useful when you call Philips Customer Care Center.

Download Firmware upgrade

1 Check you have the following tools:

 PC (Pentium III 300MHz processor or higher)

 CD-R/RW writer and writing application software

 Blank CD-R or CD-RW disc

 Internet access (broadband or high speed)

2 Click the link to download Firmware Upgrade to your PC

3 Unzip the .zip file

i) Do not rename the filename.

ii) Visit http://www.winzip.com/ for downloads if you cannot open the .zip file.

Burning Upgrade on CD-R / CD-RW

1 Extract the files by unzipping the zipped file.

2 Write the extracted files – not the zip file – onto a blank CD-R or CD-RW disc, using the following settings:

- File System CD-ROM Joliet

Tip: For more information on

burning software we suggest you

can refer to two popular burning

software programs

www.nero.com

www.easycdcreator.com

Step 1

Step 2

Step 3

PAGE 1
Firmware Upgrade Introduction The upgrade version of this software is Version 35 and can be used to upgrade Philips HTS6600/12 and HTS6600/05 to the latest status. This upgrade allows the HTS6600 to improve the following: 1. Improved picture quality Note: This upgrade is not applicable for the HTS6600 sets that support 1080p, i.e. with serial number starting with VN2A or NW2A.
PAGE 2
3 File name length : max 31 chars (ISO Level 2) Mode : 2/XA Character set : ISO 9660 Single session Write Speed : Low Finalize the disc. (The application may do this automatically.) - Using Nero Express 6 Please make sure you are using Nero Express. You can start Nero Express from the Nero folder in Windows Start menu. 1. Insert a blank CD-R or CD-RW disc. 2. Open Nero Express and select “Data disc”. 3. Click on the “Add” 4. Select the unzipped files 5. Click “Add” and “Finished”. 6.
PAGE 3
6. Click “Start Recording”, the firmware upgrade will now be burned onto the disc. Step 4 Apply Upgrade to your Set 1. 2. 3. 4. Power up the set and insert the prepared Upgrade CDR. The set will automatically start upgrading. Set‟s FTD will display ERASE, after which the tray door will open. Remove Disc from set. DO NOT close the tray door. The tray door will automatically close and the set will go to standby. Software upgrading is completed.
PAGE 4