Software Upgrade

1. For Optical Disc upgrade, follow STEP 3 to STEP 4.
2. For USB upgrade, follow STEP 5.
Burning Upgrade on CD-R / CD-RW
1. Extract the files by unzipping the zipped file with WINZIP or any other application capable of
handling zipped files (Do not rename the extracted files)
2. Write the extracted files – not the zip file – onto a blank CD-R or CD-RW disc,
using the following settings:
- File System: ISO 9660 + Joliet
- File name length : max11 chars = 8+3 (Level 1)
- Mode : 2/XA
- Character set : ISO 9660 (ISO normal CD-ROM)
- No Multi Session
- Write Speed : Low
- Recording Method: Track At Once
Note: The extracted files should not be placed in a folder on the disc but just in the top level
directory (root).
3. Finalize the disc. (The application may do this automatically.)
Apply Upgrade to your home theater system
1. Power on the set and put in the disc.
2. A message will be displayed on the OSD after the upgrade file is recognized.
3. After reading the file, the disc will be ejected
4. Remove the disc, but DO NOT close the tray
5. Wait approximately 3-5 minutes for the software to be upgraded
6. The set will automatically close the disc tray and go to standby mode once the upgrade is
completed.
7. Press Standby button to turn on the set.
Caution: Do not unplug or power off the set while upgrading in progress.
Upgrading the firmware of your Home Theatre System (USB)
Note: Do not press any buttons or interrupt the mains supply during the upgrading process,
otherwise the HTS may become defective.
Note: Check to ensure that your USB storage device can be detected by the HTS before trying to
upgrade the firmware using this method. If the USB storage device cannot be detected, please
follow STEP 3 to STEP 4 to upgrade using an Optical Disc.
Note: Use a FLASH based USB storage device. The startup time for HDD based USB storage
device is too slow and cannot be used for firmware upgrade.
1. Extract the firmware upgrade files from the ZIP archive.
2. Unzip all the files and place them on the root directory of a USB flash storage device (at least
64Mb in size).
3. Turn the HTS on, and press the “USB” button on the Remote Control to switch to USB
mode.
Step 3
Step 4
Step 5