User manual

14 EN
Before you start, check that:
• The calibration microphone is less than
5 meters (16 feet) from each of the
speakers. If it is more, set up your speakers
manually (see 'Manual setup' on page 14).
• There is nothing between the speakers and
the microphone to block the sound.
• The room is quiet. For example, switch off
your TV or radio, close doors and windows,
and switch off your air conditioning.
1 Connect the calibration microphone to the
MUSIC iLINK connector on your home
theater.
2 Place the calibration microphone as close
to the seating position as possible, at ear
height.
3 Press (Home), and then select [Setup].
4 Select [Audio] > [Auto speaker setup
(recommended)].
5 Follow the onscreen instructions to set up
the sound.
• It is normal to hear the test tones
from the speakers. Do not change the
volume or move the speakers, and
make sure that you keep quiet until the
calibration is complete.
6 After the auto calibration, disconnect the
calibration microphone and save it for
future use.
Manual setup
Set up the speakers manually to experience
customized surround sound.
Before you start
Make the necessary connections described in
the quick start guide, and then switch the TV to
the correct source for your home theater.
1 Press (Home).
2 Select [Setup], and then press OK.
3 Select [Audio] > [Manual speaker setup
(Advanced)].
4 Enter the distance for each speaker, and
then listen to the test tones and change
the volume. Experiment with the speaker
positions to nd the ideal setting.
Set up EasyLink (HDMI-CEC
control)
This home theater supports Philips EasyLink,
which uses the HDMI-CEC (Consumer
Electronics Control) protocol. EasyLink-compliant
devices that are connected through HDMI can
be controlled by a single remote control.
Note
•
Depending on the manufacturer, HDMI-CEC is known
by many names. For information on your device, see
the user manual of the device.
• Philips does not guarantee 100% interoperability with
all HDMI-CEC devices.