User manual

English
1 Important
Congratulations on your purchase and welcome to Philips! To fully benefit from the
support that Philips offers, register your product at www.philips.com/welcome.
Read this user manual carefully before you use the appliance, and save the user manual
for future reference.
Danger
• Do not immerse the motor unit in water nor
rinse it under the tap.
Warning
• Never use your fingers or an object to push
ingredients into the feeding tube while the
appliance is running. Only use the pusher.
• Before you connect the appliance to the power,
make sure that the voltage indicated on the
bottom of the appliance corresponds to the
local power voltage.
• Never connect this appliance to a timer switch,
to avoid a hazardous situation.
• Do not use the appliance if the power cord, the
plug, protecting cover, rotating sieve or any other
parts are damaged or has visible cracks.
• If the power cord is damaged, you must have it
replaced by Philips, a service center authorized
by Philips, or similarly qualified persons to avoid
a hazard.
• This appliance shall not be used by children.
Keep the appliance and its cord out of reach of
children.
• This appliance can be used by persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and if they understand the hazards involved.
• For their safety, do not allow children to play
with the appliance.
• Never let the appliance run unattended.
• If food sticks to the wall of the blender jar or
bowl, switch off the appliance and unplug it. Then
use a spatula to remove the food from the wall.
• Be careful when you are emptying the bowl,
handle or clean the discs, the blade units and the
juicer sieve. The cutting edges are very sharp.
• Do not touch the blades, especially when the
appliance is plugged in. The blades are very
sharp.
• If the blades get stuck, unplug the appliance
before you remove the ingredients that block
the blades.
• Be careful if hot liquid is poured into the food
processor or blender as it can be ejected out of
the appliance due to a sudden steaming.
• This appliance is intended for household use
only.
Caution
• Never switch off the appliance by turning the
blender jar, the bowl, or their lids. Always switch
off the appliance by turning the speed selector
to 0 or OFF.
• Unplug the appliance immediately after use.
• Always wait until the moving parts stop running,
then switch off and unplug the appliance before
opening the lid and reaching into any of the
parts that move in use.
• Always switch off and unplug the appliance
if it is left unattended, and before assembling,
disassembling, cleaning and changing accessories,
or approaching parts that move in use.
• Thoroughly clean the parts that come into
contact with food before you use the appliance
for the first time. Refer to the instructions and
table for cleaning given in this manual.
• Never use any accessories or parts from other
manufacturers that Philips does not specifically
recommend. If you use such accessories or parts,
your guarantee becomes invalid.
• Do not exceed the maximum level indication
on the bowl or the jar. Follow the quantities,
processing time and speed as indicated in the
user manual.
• Let hot ingredients cool down (< 80ºC) before
processing them.
• Always let the appliance cool down to room
temperature after each batch that you process.
• Certain ingredients such as carrots may cause
discolorations on the surface of the parts. This
does not have a negative effect on the parts. The
discolorations usually disappear after some time.
• Noise level: Lc = 85 dB [A]
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and regulations regarding
exposure to electromagnetic fields (EMF). If handled properly and according to the
instructions in this user manual, the appliance is safe to use based on scientific evidence
available today.
Recycling
Do not throw away the product with the normal household waste at the end of its
life, but hand it in at an official collection point for recycling. By doing this, you help to
preserve the environment.
2 Introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from the
support that Philips offers, register your product at www.philips.com/welcome.
This appliance is equipped with a built-in safety lock. You can only switch on the
appliance after you correctly assemble the following parts on the motor unit:
• the food processor bowl and its lid, or
• the blender jar and its lid (HR7628, HR7629 only), or
• the citrus press (HR7629 only)
If these parts are assembled correctly, the built-in safety lock is unlocked.
For recipes to use with your food processor, go to www.philips.com/kitchen
3 Food processor
Warning
•
Never use your fingers or an object to push ingredients into the feeding tube while the
appliance is running. Only use the pusher.
Blade unit
Before you start, make sure you assemble according to Fig. 2.
You can use the blade unit to chop, mix, blend, or puree ingredients. You can also use it
to mix and blend cake batters.
Caution
•
Do not use the blade unit to chop hard ingredients, like coffee beans, turmeric, nutmeg, and
ice cubes, as this may cause the blade to get blunt.
Note
•
Do not let the appliance run too long when you chop (hard) cheese or chocolate. Otherwise
these ingredients become too hot, start to melt, and turn lumpy.
•
Precut large pieces of food into pieces of approx. 3 x 3 x 3 cm.
1
Turn the the bowl clockwise to fix it on the motor unit, and then put the tool
holder in the bowl.
»
When the bowl is fixed correctly, you hear a click.
2
Put the blade unit on the tool holder.
3
Put the ingredients in the bowl.
4
Put the lid on the bowl, and then turn the lid clockwise to fix it.
»
When the lid is assembled correctly, you hear a click and the lid is fixed to the
bowl handle.
5
Put the pusher into the feeding tube.
6
Connect the power plug to the power supply.
7
Check the preparation time, the maximum amount and the speed setting required
for the ingredients in Table 1. Turn the knob to the desired speed setting.
8
After use, turn the knob to 0, and then unplug the appliance.
Tip
•
When you chop onions, turn the knob to P
(
瞬間加速
)
a few times to prevent the onions
from becoming too finely chopped.
•
How to remove food that sticks to the blade or to the inside of the bowl? 1. Switch off the
appliance, and then unplug it. 2. Remove the lid from the bowl. 3. Remove the ingredients
from the blade or from the side of the bowl with a spatula.
© 2019 Koninklijke Philips N.V.
All rights reserved.
9
10 11 12
0
1
2
ᐁ
ං
˱
஠
2
3 4
5
6

7
8
4 min 1 kg 1
20 sec 500 g1
30 sec 500 g
1
30 sec 200 g
1
30 sec 2 pcs
1
30 sec
500
g
1
(HR7629)
(HR7629)
1 min1
L2
1 min1
L2
1 min1
L2
P x 9
P
(HR7628, HR7629)
6 x
1
(MAX)
(MAX)
(MAX)
(MAX)
5 x 1 sec 500 g
5 x 1 sec 500 g P/2
30 sec 50 g
60 sec 250 g2
45 sec 250 g2
30 sec 200 g2
2-3 min 500 g
360 ml
350 ml
4 pcs
1
1
1
30 sec 500 g1
30 sec 500 g1
(HR7627, HR7628)
60-180 sec
60-180 sec
0
1
2
30 sec 300 g1
400 g
3 min
600 ml
2
30 sec 2 pcs 1
P
P
MAX: ௖ɣ sec: ެ min: ʗ pcs: ࠯ P: ᐁං˱஠
4240 002 01465
TC
使用手冊
EN User manual
Kneading accessory
Before you start, make sure you assemble according to Fig. 3.
You can use the kneading accessory to knead yeast dough for bread and pizzas. You
need to adjust the amount of liquid to form the dough according to the humidity and
temperature condition.
N
ote
•
Do not use the kneading accessory to blend cake batters. Use the blade unit for this job.
•
Always put the kneading accessory in the bowl before you add the ingredients.
1
Turn the the bowl clockwise to fix it on the motor unit, and then put the tool
holder in the bowl.
»
When the bowl is fixed correctly, you hear a click.
2
Put the kneading accessory on the tool holder.
3
Put the ingredients in the bowl.
4
Put the lid on the bowl, and then turn the lid clockwise to fix it.
»
When the lid is assembled correctly, you hear a click and the lid is fixed to the
bowl handle.
5
Put the pusher into the feeding tube.
6
Connect the power plug to the power supply.
7
Turn the knob to the 1 position.
8
Check the preparation time, the maximum amount and the speed setting required
for the ingredients in Table 1.
9
After use, turn the knob to 0, and then unplug the appliance.
Discs and Inserts
Before you start, make sure you pick your desired disc from following and assemble
according to Fig. 4 and Fig. 5.
• Emulsifying disc
• Insert for fine slicing (HR7627 and HR7628 only)
• Insert for coarse shredding (HR7627 and HR7628 only)
• Insert for granulating (HR7627 and HR7628 only)
• Reversible slicing / shredding disc (coarse) (HR7629 only)
Caution
•
Be careful when you handle the slicing blade of disc. It has a very sharp cutting edge.
•
Never use the disc to process hard ingredients, like ice cubes.
•
Do not exert too much pressure on the pusher when you press ingredients into the feed
tube.
Note
•
Precut large ingredients into chunks that fit in the feeding tube.
1
Turn the bowl clockwise to fix it on the motor unit, and then put the tool holder
in the bowl.
»
When the bowl is fixed correctly, you hear a click.
2
Put the disc on the shaft. For inserts (HR7627 and HR7628 only), place an insert
in the insert holder as indicated below, then place the insert holder with insert on
the shaft.
Place the opening of the insert over the shaft of the insert holder.
Push the opening of the insert over the projection on the shaft.
Press the insert onto the insert holder until it locks in position with a click.
3
Put the lid on the bowl, and then turn the lid clockwise to fix it.
»
When the lid is assembled correctly, you hear a click and the lid is fixed to the
bowl handle.
4
Put the ingredients into the feeding tube with the pusher. Fill the feeding tube
evenly for the best results. When you have to process a large amount of
ingredients, process small batches and empty the bowl between batches.
5
Connect the power plug to the power supply.
6
Check the preparation time, the maximum amount and the speed setting required
for the ingredients in Table 1. Select the speed that matches the color of the
accessory.
7
After use, turn the speed selector to 0, and then unplug the appliance.
HR7629