User Guide

ManualsBrandsPhilips ManualsJuicersHR1851

ENGLISH 7

Preparing for use

Wash all detachable parts (see chapter

‘Cleaning’).

2 Pull the mains cord out of the cord storage

compartment at the back of the appliance.

3 Attach the spout to the juice collector by

snapping it into position.

4 Place the juice collector onto the appliance and

put the lter in the juice collector. Make sure

the lter is tted securely onto the driving

shaft.

Always check the lter before use. If you detect

any cracks or damage, do not use the appliance and

contact the nearest Philips service centre or take

the appliance to your dealer.

5 Attach the pulp container to the appliance by

aligning the latch on the pulp container with

the slot on the motor unit and then pushing

the pulp container home. Hold the lid over the

lter and lower it into position.

While you are preparing juice, you can empty the

pulp container by switching the appliance off and

carefully removing the pulp container.

Note: Reassemble the empty pulp container before you

continue juicing.

6 Snap the two clamps onto the lid to lock it into

place (‘click’). Slide the pusher into the feeding

tube.

Make sure the clamps are locked into position on

either side of the lid.

7 Place the juice jug under the spout.

The juice jug has a removable foam separator to

separate the foam from the juice when pouring the

juice into a glass.

Using the appliance

The appliance will only function if all parts have been

properly assembled and the lid has been properly

locked in place with the clamps.

Do not operate the juicer for more than 40

seconds at a time when juicing heavy loads and let

it cool down afterwards. None of the the recipes

in these instructions for use constitute heavy loads.

1 Wash the fruit and/or vegetables and cut them

into pieces that t into the feeding tube.

2 Make sure the spout has been attached to

the juice collector and the juice jug has been

placed under the spout.

3 Switch the appliance on by turning the control

knob to setting 1 (low speed) or 2 (normal

speed).

Speed 1 is especially suitable for soft fruits and

vegetables such as watermelons, grapes, tomatoes,

cucumbers and raspberries.

Speed 2 is suitable for all other kinds of fruits and

vegetables.

4 Put the pre-cut pieces in the feeding tube and

gently press them down towards the rotating

lter by means of the pusher.