blender fruit filter HR1744
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed including the following: Read all instructions before using. 1. To protect against electrical shock, do not immerse cord, plug, blender unit, or motor unit in water or other liquid. 2. Close supervision is necessary when any appliance is used by or near children. 3. Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning. 4.
13. Make sure the motor and the blades completely stop turning before putting on or taking off parts. 14. Keep hands, hair, and clothing, as well as spatulas and other utensils out of blender jar and away from sharp blades while blending to prevent the possibility of severe injury to persons and/or damage to the Blender. If scraping, folding, etc., is necessary, Blender must be turned off and unplugged, and only use a rubber spatula. 15. Blades are sharp. Handle carefully and with caution. 16.
in the correct position before you use the Blender. 27. The blender base is intended for use only with this blender jar. Do not substitute any other blender jar. 28. This Blender has been equipped with an automatic safety cut-out which cuts off the power supply in case of an overload. In this case, the pin at the bottom of the Blender will pop out. If you push the pin back into the appliance, it will start again.
Table of Contents Features 2 Important 3 Before Use 4 Preparing the Blender for Use 4-5 Using Blender 5-6 Helpful Hints 6 Using the Fruit Filter 7-8 Helpful Tips Using the Fruit Filter 8 Cleaning 8-9 For Assistance 9 Warranty Back Cover
2 Features Stopper/Blender Measuring Cup Pour In Opening Lid Lid Strainer Pouring Spout Blender Jar Level Indications Cups/Ounces Rubber Sealing Ring Mixing Blades Blade Unit Fruit Filter Motor Unit M= Momentary (Pulse Position) Quick Clean Button Cord Storage Speed Buttons 3 = High Speed 2 = Normal Speed 1 = Low Speed O = Off Rubber Safety Suction Feet
3 Important: • Read the instructions carefully and look at the illustrations before you start using the appliance. • Failure to properly insert filter may cause damage to filter unit from cutting blades. • Do not fill the blender jar with ingredients that are hotter than 140°F/60°C. • To avoid spillage, do not fill the jar above the maximum level indication (5 cups/1.25 liters), particularly when you are blending liquids. Always insert the stopper into the lid before you start processing.
4 Before Use Before using the Philips Blender for the first time, wash the stopper, lid, fruit filter and blender jar in lukewarm soapy water to remove any dust from packaging. C NOTE: Never clean accessories or parts in the dishwasher. The motor unit can be cleaned with a moist cloth. Do not use abrasives, scourers, alcohol, etc. You can store excess power cord by winding it around the base of the appliance.
5 C 5 Insert the stopper into the opening in the lid. When finished, make sure that the sieve of the lid is positioned in the spout to pour liquids. C 6 Always make sure that you remove the blender jar from motor unit with the blade unit still attached to the jar. Never touch the blades of the blade unit while the appliance is connected to the power source. To disassemble the blender, follow steps in reverse order. Using the Blender 1 Place the Philips Blender on a flat, dry, clean surface.
6 C 5 To switch the appliance off, when using speed 1, 2, or 3, press the “O” button. Helpful Hints C C 1 The stopper may be used as a measuring cup by placing the stopper upside down in the lid. 2 The opening in the lid can be used for adding ingredients while the motor is running. 3 Do not let the appliance run for longer than 3 minutes at a time. If you have not finished processing after 3 minutes, switch the appliance off (O) for one minute before you let it run again.
7 Using the Fruit Filter With this filter you can make delicious fresh fruit juices and cocktails. All pits, skins, and seeds will remain behind in the filter. However, large hard pits (e.g. peach, nectarine, avocado, etc.) should be removed before adding fruit so as not to jam the blades. C 1 Assemble the blender jar. 2 Place the filter in the assembled blender jar. Make sure that the bottom of the filter is connecting with the internal bottom of the blender jar.
8 IMPORTANT: Do not remove the filter before you have poured all liquid out of the Blender. If you do, the contents of the filter will fall into the remaining liquid in Blender Jar. Helpful Tips Using the Fruit Filter Particularly when you are processing large quantities, we advise that you do not put all the ingredients in the filter at the same time. Start processing a small quantity, let the Blender run for a moment, switch it off by pressing the “O” button and then add another small quantity.
9 11 12 13 14 Always wait until the motor is off and the blades have stopped moving. Unplug the appliance. Remove the blender jar and rinse it with clean water. Thorough cleaning: remove the blade unit and clean all parts separately. CAUTION: Handle the cutting blades with extreme care and caution.They are sharp and may cause injury. Filter 16 17 18 19 20 Take the filter out of the blender jar. Hold the filter over a waste bin and gently shake out the contents of the filter.
FULL ONE YEAR WARRANTY Philips Electronics North America Corporation warrants each new Philips product, model HR1744 (except cord), against defects in materials or workmanship for a period of one year from the date of purchase. IMPORTANT: This warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable care, the affixing of any attachment not provided with the product or loss of parts or subjecting the product to any but the specified voltage.
