User manual

Use the quantities and processing times of the mini chopper for this
accessory.
Guarantee and service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you nd its phone number in the worldwide
guarantee leaet). If there is no Consumer Care Centre in your country, go
to your local Philips dealer.
Ingredients Chopping
quantity
Time Speed
Parmesan cheese 50-100g (max) 15sec. turbo
Nuts and almonds 100g 20sec. turbo
Garlic 50g 5 x 1sec. turbo
3 Put the coupling unit on the chopper bowl (Fig. 6).
4 Fasten the motor unit onto the chopper lid (‘click’) (Fig. 7).
5 Put the plug in the wall socket.
6 Press the on/off button or the turbo speed button to switch on the
appliance.
Note: If the ingredients stick to the wall of the chopper bowl, loosen them with
a spatula or by adding liquid.
Note: Do not process more than 1 batch without interruption. Let the appliance
cool down for 5 minutes before you continue processing.
Whisk (HR1613 only)
The whisk is intended for whipping cream, whisking egg whites, desserts etc.
1 Connect the whisk to the coupling unit (‘click’) (Fig. 8).
2 Connect the coupling unit to the motor unit (‘click’) (Fig. 9).
3 Put the ingredients in a bowl.
See the table for the recommended quantities and processing times.
Whisking quantities and processing times (HR1613 only)
Ingredients Whisking quantity Time
Cream 250ml 70-90sec.
Egg whites 4 eggs 120sec.
Tip: When you beat egg whites, use a large bowl for the best result.
Tip: When you whip cream, use the beaker to avoid splashing.
Tip: To prevent splashing, start at a low speed setting and continue with a higher
speed after approx. 1 minute.
Note: Do not process more than 1 batch without interruption. Let the appliance
cool down for 5 minutes before you continue processing.
4 Plug in the appliance and press the on/óff button.
5 After approx. 1 minute, you can press the turbo button to continue at
turbo speed.
Cleaning (Fig. 10)
Do not immerse the motor unit, the whisk coupling unit (HR1613 only),
or the coupling unit of the mini chopper (HR1613/HR1611 only) in water.
1 Unplug the appliance.
2 Press the release buttons on the motor unit to remove the accessory
you used.
3 Disassemble the accessory.
Tip: You can also remove the rubber ring from the chopper bowl for extra
thorough cleaning.
4 See the separate cleaning table at the end of this user manual for
further instructions.
Tip: For quick cleaning, pour warm water with some washing-up liquid in the
beaker, insert the blender bar and let the appliance operate for approx. 10
seconds.
Storage
1 You can store the motor unit, the blender bar and the whisk (HR1613
only) in the beaker (Fig. 11).
Environment
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an ofcial collection point for
recycling. By doing this you help to preserve the environment (Fig. 12).
Accessories
You can order a direct-driven mini chopper (under service code number
4203 035 83450) from your Philips dealer or a Philips service centre as an
extra accessory for the HR1613, HR1611 and the HR1610.
3
4222.005.0111.1