User manual

and rell the cleaning chamber (see chapter
‘Cleaning and maintenance’).
- The shaving heads may be damaged or worn.
Replace the shaving heads (see chapter
‘Replacement’).
- Long hairs may be obstructing the shaving heads.
Clean the cutters and guards with the brush
supplied (see chapter ‘Cleaning and maintenance’).
2 The shaver does not work when I press the
on/off button.
- The battery may be empty. Recharge the battery
(see chapter ‘Charging’) or connect the shaver to
the mains.
- The travel lock may be activated. Press the on/off
button for 4 seconds to deactivate the travel lock.
- The temperature of the shaver may be too high.
In this case, the shaver does not work. As soon
as the temperature of the shaver has dropped
sufciently, you can switch on the shaver again.
3 The shaver is not entirely clean after I clean it
in the Jet Clean System.
- The cleaning uid in the cleaning chamber may be
soiled. Empty and rinse the cleaning chamber.
- The cleaning uid level may be too low. If the
uid volume in the cleaning chamber drops
below the minimum level during the cleaning
program, the program aborts.The cleaning symbol
and the ‘uid low’ symbol ash at intervals and
the holder returns to its starting position. Rell
the cleaning chamber with cleaning uid up to
the MAX indication (see chapter ‘Cleaning and
maintenance’).
- You may have used another cleaning uid than
the original Philips cleaning uid. Only use HQ200
cleaning uid.
ENGLISH 27