User manual

Charging
Make sure the shaver is switched off before you charge it.
Charging takes approx. 1 hour.
You can also shave without charging by connecting the shaver to the mains.
A fully charged shaver has a cordless shaving time of up to 55 minutes.
1 Chargetheshaverwhenthebottomlightashesorange.
Charge indications
Charging
- When you start charging the empty shaver, the bottom light ashes
orange. When the battery contains enough power for one shave, the
middle charging light starts ashing green (Fig. 6).
Battery fully charged
- When the battery is fully charged, the top charging light lights up
green continuously.
Battery low
- When the battery is almost empty i.e. when there are only 5 or less
shaving minutes left, the bottom charging light starts to ash orange.
When you switch off the shaver, this light still ashes orange a few times.
Charging with the adapter
1 Puttheapplianceplugintheshaver(Fig.7).
2 Puttheadapterinthewallsocket.
3 Remove the adapter from the wall socket and pull the appliance
plugoutoftheshaverwhenthebatteryisfullycharged.
Charging in the Jet Clean system
1 Place the shaver in the holder and completely push down the lever
tolocktheshaverintoplace(Fig.8).
, ThecharginglightontheJetCleansystemashestoindicatethat
theshaverischarging.
, Whenthecharginglightlightsupcontinuously(afterapprox.1
hour),theshaverisfullycharged(Fig.9).
ENGLISH8