User manual

Cleaning and maintenance
The best and most hygienic way to clean the shaver is in the Jet Clean
system. You can also clean the shaver by rinsing it under the tap or with
the brush supplied.
Regular cleaning guarantees better shaving performance.
Note: Water may leak from the socket at the bottom of the shaver when you
rinse it. This is normal and not dangerous.
Cleaning the shaver in the Jet Clean system supplied
Preparing the Jet Clean system for use
Fill the cleaning chamber before rst use and when the cleaning light
ashes to indicate that the uid level is too low. When the uid level
drops below the minimum level, the cleaning light ashes with intervals
and the holder returns to its starting position.
If you use the Jet Clean system to clean the shaver every day, rell the
cleaning chamber approx. every 15 days.
1 Simultaneously press the release buttons on both sides of the
cleaningchamber(1)andlifttheJetCleansystemoffthecleaning
chamber(2)(Fig.15).
The cleaning chamber remains behind.
2 Unscrew the dosing cap from the bottle with HQ200 Cleaning
Fluidandremovetheairtightseal.
3 FillthecleaningchamberwithcleaninguiduptotheMAX
indication(Fig.16).
4 PlacetheJetCleansystembackontothecleaningchamber(Fig.17).
Make sure the release buttons snap back into place.
5 Put the appliance plug in the Jet Clean system and put the adapter
inthewallsocket(Fig.18).
, Theholderautomaticallymovestothehighestposition.
The Jet Clean system is now ready for use.
ENGLISH10