Register your product and get support at www.philips.
l i e f m j d c b a g n h k o q p
English Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. 1 Important Read this user manual carefully before you use the appliance and keep it for future reference. •• WARNING: Do not use this appliance near water. •• When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a risk, even when the appliance is switched off.
•• If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. •• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Hairstyle Attachment Dry hair (HP8651 only) Concentrator ( ) Volume and shine Polish brush ( ) Volume or flicks (HP8651 only) Thermo brush ( ) Waves or curls Retractable bristle brush ( ) Straight style Straightening comb ( ) Before you style your hair: 1 Snap a suitable attachment onto the styler (a & l). •• If the bristles are retracted inside the retractable bristle brush, turn the bristle retraction knob (g) to extract the bristles (p).
•• To create flicks, brush the hair downwards and turn the brush inwards (n) or outwards (o) at the hair tip. Hold the brush in that position for 2 to 3 seconds, and then remove it from your hair. 2 To style the rest of your hair, repeat step 1. Create waves and curls: 1 Wind a section of hair round the brush with the bristles extracted. 2 Keep the brush in the position until the hair is dry (max. 15 seconds), and then retract the bristles to remove the brush from your hair.
4 Troubleshooting Problem The appliance does not work at all. Cause The power socket to which the appliance has been connected may not live. The appliance may have overheated and switched itself off. The appliance may not be suitable for the voltage to which it has been connected. Solution Ensure the socket is live. Unplug the appliance and let it cool down for a few minutes. Before you switch on the appliance again, check the grilles to make sure they are not blocked by fluff, hair, etc.
© Royal Philips Electronics N.V. 2010 All rights reserved. Specifications are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners.
