operation manual

When used in a bathroom, unplug the appliance after use since
the proximity of water presents a risk, even when the appliance is
switched off.
◗ For additional protection, we advise you to install a residual
current device (RCD) with a rated residual operating current not
exceeding 30mA in the electrical circuit supplying the bathroom.
Ask your installer for advice.
◗ Always make sure that the attachments are completely dry - on
the inside as well as on the outside - before you fit them onto the
styler.
◗ The attachments will become hot during use. Prevent contact
with the skin.
◗ Never block the air inlet grille.
◗ Regularly detach the air inlet grille and clean it with a moist cloth.
If the air inlet grille is not cleaned regularly, it may get blocked
and the appliance may overheat. (fig. 2)
◗ If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
put the plug back into the socket again, check the grille to make
sure it is not blocked by fluff, hair, etc.
◗ Always unplug the appliance after use.
◗ Keep the appliance away from children.
◗ Wait until the appliance is cool before storing it.
◗ Always switch the appliance off before putting it down, even for a
moment.
Preparing for use
Hair
1 The Slim Powerstylist is most effective when the hair is slightly
damp. Slightly dampen your hair when it is dry. Never use the
appliance on wet hair!
2 Comb or brush the hair so that it is untangled and smooth.
3 Use a comb to divide the hair into locks.
Do not put too much hair in one lock.
ENGLISH 7