Operation Manual

– 40 –
5.2 Volume of the ring signal
You can adjust the volume of the ring signal, if the machine is in standby mode or if ringing.
Press the CURSOR LEFT or CURSOR RIGHT key. The display
shows the current setting for about 3 seconds.
RINGER: ßß
FINE PHOTO BUSY TEL TEL/FAX
EXT.
Change the volume by pressing the CURSOR LEFT or CURSOR
RIGHT keys until the desired volume is achieved.
RINGER: ßßßß
FINE PHOTO BUSY TEL TEL/FAX
EXT.
5.3 Remote diagnostics
(not available in all countries)
The remote diagnostics function is normally switched off. When it is switched on, our service department can
access some of your fax machine’s technical data over the telephone line, and can make changes to these if
necessary. This is useful in the event of a breakdown and can bring rapid assistance. You will first have to switch
the remote diagnostics on. After 24 hours remote diagnostics is automatically blocked again.
FUNCTION
1
4
7
2
5
8
0
3
6
9
#
∗
Select function 41.
41 REMOTE OPER.
FINE PHOTO BUSY TEL TEL/FAX
EXT.
OK
Press the OK key.
REMOTE OPER.:OFF
FINE PHOTO BUSY TEL TEL/FAX
EXT.
OK
Select using the CURSOR LEFT or CURSOR RIGHT key, then
press the OK key.
4 OTHERS
FINE PHOTO BUSY TEL TEL/FAX
EXT.
The remote diagnostics is a very good tool to make changes in the programming of your fax
machine. It is however not suitable for making any repairs concerning electrical or mechanical
defects.
5.4 Mercury
The two services of Mercury Communications Limited (MCL), the residential 132 and the Pin code service, can be
accessed via most existing British Telecom (BT) lines. In case of any doubt ask MCL Customer Assistance (0500
500 194) which one is available at your location.
Before you can use the Mercury button, function 27 must be set according to the service you have access to.