Operation Manual

– 26 –
Feeding documents in
Take the first page of the document and place it face up as shown in the picture.
Slide the document into the fax along the document guide on the left hand side
of the feed slot until it stops. Wait for a moment: The document will now be
slightly drawn in automatically by the feeding mechanism.
Once the document has been drawn in by the transport mechanism, it should
not be pushed in any further , otherwise the top part will be missing when you
make a copy or transmit a fax.
Leave some space on the upper edge of your document (about 4 mm). This part cannot be
scanned and therefore will not be sent.
Sending
1
4
7
2
5
8
0
3
6
9
#
∗
Dial the number you require.
12345
FINE PHOTO BUSY TEL TEL/FAX
EXT.
Insert the first page of your document face up into the paper feed
slot.
RESOLUTIO
N
You can select a higher resolution by pressing the RESOLUTION
key. The corresponding pointer on the display will light up.
12345
FINE PHOTO BUSY TEL TEL/FAX
EXT.
START
COPY
Press the START/COPY key.
DIALLING...
FINE PHOTO BUSY TEL TEL/FAX
EXT.
The machine is attempting a connection.
CONNECTING...
FINE PHOTO BUSY TEL TEL/FAX
EXT.
If the number you are calling is engaged or you cannot make a connection, your machine will
automatically redial the number. If a connection is not made after the third attempt, the procedure
will stop.
Transmission now begins. The recipient fax machine will now
transmit its sender identification, which will appear in your display.
[phone]
FINE PHOTO BUSY TEL TEL/FAX
EXT.
You can now check again whether you have dialled the correct number. If necessary you can
interrupt transmission by pressing the STOP key.