Operation Manual

– 18 –
STO
P
Press the STOP key. The thermal paper is now pressed against
the transport roll inside the machine and is ready for being
transported.
Tear off the paper protruding from the machine, by tearing it along the paper tear
strip, starting at one side of the paper.
If you do not press STOP, the machine will automatically bring the thermal paper into the correct
position to be fed through the machine when you copy, send or receive for the first time.
At the end of the fax reception wait at least 5 seconds before tearing off the fax, just to be sure that
the fax transmission has finished.
Press the START key to feed the paper through; it will feed through as long as you keep the key
pressed.
Removing fax paper during use
If you want to remove the thermal paper, for example because you want to insert a new roll or there is a paper
jam, follow these steps:
STO
P
Press STOP for 3 seconds. A confirmation signal will sound. Now
the thermal paper roll is free and the paper can be easily removed.
To load thermal paper, proceed as described above.
If you do not follow these steps you might damage your fax machine!
The black stripe at the end of the paper roll indicates to the fax machine that the paper is about to
run out. As soon as the stripe is visible, the fax currently being received will be completed but no
more faxes will be received.