Operation Manual

– 17 –
The paper compartment is set to a paper width of 210 mm. If you want to use
paper rolls with a width of 216 mm, remove the paper adjustment part.
Unwrap the new paper roll. Cut the leading edge of the thermal paper, so that
any sticker is totally removed. Cut it in a straight line and cut the edges as
indicated on the picture, this will make feeding the paper easier. Hold it so that
the paper unrolls in the direction away from you when you pull the paper upwards.
Place the paper roll in the compartment as illustrated. Pull out approximately 15
cm of paper.
Slide the leading edge of the paper into the paper feed slot until it protrudes from
the front of the machine.
If your local copy or received faxes are blank, the document or the thermal paper are inserted the
wrong way.
Help for feeding in the thermal paper:
If you have problems feeding in the paper (for example because there is not much fax paper left and it is curling):
START
COPY
Press the start key. The rubber roll inside the machine starts turning.
Now insert the paper as normally. The turning roll will help you
feed the paper through the machine. The roll will turn for about 30
seconds and will then stop automatically.
Close the inner paper cover and the operation panel.