User manual

The female massager only ts properly in the charging case with the
buttons facing up.
The male massager only ts properly in the charging case with the
buttons facing down.
The massagers switch off automatically when you place them in the
charging case and close the lid.
Note: The charging case does not work when the massagers are placed
incorrectly or when the lid is open.
Note: You can also charge one massager at a time.
4 Close the lid of the charging case. (Fig. 3)
Note: The charging case does not work if the lid is open.
The charging light on the charging case starts ashing to indicate
that the massagers are being charged.
Note: When you charge the massagers for the rst time or after a long
period of disuse, it may take a few minutes before the charging light starts
ashing. This is normal.
Note: The massagers may produce a smell the rst few times you charge
them. This is normal.
When the massagers are fully charged, the charging light goes out.
Using the appliance
Note: The massager shown in the gures is the female massager. The male
massager has the same buttons and functionalities.
Thoroughly clean the massagers before rst use, after every use and
when you use them on another body area, to reduce the risk of
infection (see chapter ‘Cleaning’).
1 Press any button to switch on the massager (Fig. 4).
The light ring goes on.
The massager starts operating in the default mode (mode 1) and
at moderate vibration speed.
-
-
,
,
,
,
ENGLISH 9