User manual

late evening (and again a couple of hours later, if you can) each night,
starting 2-3 days before you leave. Use the goLITE BLU energy light 2-3
hours later each successive night. When you arrive at your destination, try
to stay awake until bedtime and avoid bright evening light (wear
sunglasses) for the rst few days. Before you travel home, avoid any bright
afternoon and evening light and use your goLITE BLU energy light in the
morning for a few days (see above under ‘Travelling east’).
For more instructions on how to avoid jet lag, visit www.philips.com/golite.
Charging
Note: You can also use the appliance while it is charging.
The goLITE BLU energy light comes with a 9.5V AC/DC adapter
that operates on voltages ranging from 100 to 240 volts to allow
worldwide use. The adapter comes with a set of exchangeable adapter
plugs that t most common worldwide wall sockets.
1 Put the adapter in the wall socket.
2 Insert the appliance plug into socket on the appliance (Fig. 4).
, Only the outline of the charge indication is visible.
, As the battery charges, the four bars of the charge indication ash
one by one and ll as the charge increases.
, When the battery is fully charged, the charge indication stops
ashing.
Note: Charge the goLITE BLU energy light at least 8 hours before you use it
for the rst time. Charging normally takes 3 to 4 hours.
Note: When the battery is fully charged, it contains enough energy for 3 to 5
treatments.
Installation
1 Remove the stand from the stand storage cavity (Fig. 5).
2 Insert the bevelled end of the stand into the hole on the back of
the appliance. Magnets hold the stand in place (Fig. 6).
ENGLISH14