User manual

Overview 5
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN!
Power supply
Before turning on the product, check that
the power outlet that you are going to plug
conforms to the indications shown on the
information plate (voltage, current, power
network frequency) located on the projector.
This projector shall be connected to a single
phase power network.
Only use the power cable that is supplied with
the product. The product is delivered with
a grounded power cable. It is imperative to
connect a grounded connector to a grounded
outlet which is connected to the building
earthing.
The power outlet shall be installed near the
product and shall be easily accessible.
To remove all electrical power from the product,
disconnect the power cable from the power
outlet. Only in case of danger, the power cable
is the disconnect device for this product.
CAUTION!
Always use the button to turn the
projector off. This is essential to allow
the necessary cooling-down time for
the UHP lamp!
Turn off the product and unplug from the
power outlet before cleaning the surface of
the product (see Cleaning, page 23). Use a
soft, lint-free cloth. Never use liquid, gaseous
or easily flammable cleaners (sprays, abrasives,
polishes, alcohol). Do not allow any moisture to
reach the interior of the product.
DANGER!
Risk of eye irritation!
This projector is equipped with a
long-life UHP lamp, which emit very
bright light. Do not look directly into
the projector lens during operation.
This could cause eye irritation or
damage.
2 Overview
Top view
a
bce dfg
a
Projection lens
b
(Power/LED indicator)
• Press once to switch the projector on
• Press twice within one second to switch
the projector to standby.
• When the projector is in standby,
the power LED turns red.
• When the projector is switched on,
the power LED turns green.
• When the projector is in Bluetooth
mode, the power LED turns blue.
CAUTION!
Always use the button to turn off
the projector. T
his is essential to allow
the necessary cooling-down time for
the UHP lamp!
c
+/-
Adjust image sharpness.
• Switch the projector to Bluetooth mode.
• Disconnect the currently connected
Bluetooth device to connect another
Bluettooth device.
d
OK
Confirm a selection or entry.
e
Navigation buttons
• Navigate menu options.
• Press / to change a selection.
f
Return to a previous menu screen.
g
Access the projector system settings.